625 RIVERSIDE RD SEPA 016 - 028 - FREIGHT HANDLING FACILITY Land Use Decision Documents 2025-04-21

13. Any broken or damaged sidewalk/public right-of-way shall be repaired/replaced in accordance with current City of Everett Standards and per the City Public Works Inspector. 14. All roadways must meet City of Everett Standards. 15. All sidewalks and driveways must be ADA compliant. 16. Parking layout must be consistent with current City of Everett Standards, including but not limited to parking aisle widths and parking stall dimensions. 17. Fire hydrants must be a minimum of 50'from any building and a maximum of 200'. 18. If any construction dewatering is to discharge to the sewer main, a discharge authorization may be required to be obtained from the City. Construction plans must address if this will take place so the proper processing can take place during formal review for permit approval. 19. Proper rodent abatement shall be implemented prior to demolition of the existing building. 20. Special charges for connection to the sewer and water systems in accordance with Ordinance 3095-08 (codified as EMC 14.08.135) and subsequent revision are applicable. These charges are based on projected water usage and can be substantial. Applicant is encouraged to obtain a copy of the Ordinance and determine estimated charges prior to building permit application. The actual charges shall be computed by the Public Works Department per the ordinance in effect at the time and according to the information on the approved plans at the time of building permit issuance. Fire Department -Jim Venturo (425)257-8124 21. Access-The International Fire Code requires that all new structures shall provide Fire Department access roads to within 150 feet exterior walking distance of all portions of the ground floor. Fire Department access roads (Fire Lanes) shall provide a minimum of 20 feet in width of unobstructed, paved driving surface, exclusive of shoulders, with a minimum clear height of 13'6". Inside turn radii must be 35 feet. Outside turn radii must be 55 feet for ladder apparatus. Slope approach and departure angles must not exceed 8 degrees. Fire lane grade must not exceed 10 percent. Fire lane construction must comply with AASHTO H30 load capacity (74,000 GVW). Fire Lanes will be posted and maintained as required by the Fire Department. Unorthodox access which meets code requirements but is too unusual for crews, will not be allowed. Call Fire Marshal's Office for apparatus specifications. 22. Access-O.K. as shown on the site plan reviewed. 23. When access to or within a structure or an area is unduly difficult because of secured openings or where immediate access is necessary for life saving or fire-fighting purposes, the Fire Department may recommend or require a key box to be installed in an accessible location. A rapid entry system may also be desirable in order to avoid unnecessary damage while making entry to any building during an emergency situation. All gates need Knox Key override and emergency strobe opener installed. Call AFM Jim Venturo (425) 257-8124 for specifications. 24. A Knox Box is required. 2015 IFC 506.1 Recessed box required. Order Box#3270. Mount by access to alarm/sprinkler room. 25. Knox fire department connection caps are required for all outside FDC and standpipe connection points. Order caps#3043 for FDC connection. NOTE: For all Knox items, go to www.everettfire.orq to order. 26. Fire lanes shall be provided as required in Everett Municipal Code 46.44. Fire lanes shall be identified by red curbs with white stenciling stating "NO PARKING- FIRE LANE" and vertical signs stating "NO PARKING—FIRE LANE—TOW AWAY ZONE—EMC 46.28.130". Location shall be approved by the Fire Code Official. Per field evaluation from Fire Marshal's office. Sig-