625 RIVERSIDE RD SEPA 016 - 028 - FREIGHT HANDLING FACILITY Land Use Decision Documents 2025-04-21

27. Premises shall be clearly identified by 12 inch numbers showing the correct address at the street entry. Buildings shall be clearly identified so as to be visible and legible from the access road. Individual apartments and suites, where applicable, shall be clearly and legibly identified from the access road. 28. The Everett Municipal Code and the 2015 International Fire Code, Appendix C, table C102.1, and requires that fire hydrants be provided within a maximum distance and of sufficient number and spacing to all new construction. The distance and number of hydrants varies based on type of construction and occupancy of the structure. 29. A fire hydrant shall be located within 100 feet of a fire department connection or standpipe. 30. A fire hydrant is required within 200 driving feet, but not closer than 50 feet, of each structure. Location of the hydrant(s) shall be approved by the Fire Code Official. (1) Fire Hydrants need to be placed on small island stubs, not behind parking stalls. (2) Employee parking area needs hydrant relocated into parking area. (3) Place two additional hydrants by PUP parking area#33 and tractor parking area#53 on site plan. 31. Fire flow for this project is 2000 gpm. 32. Portable Fire Protection -A portable fire extinguisher with a minimum U.L. rating of 2-A:10-B:C shall be provided within 75 feet of travel on all floors of each building during construction and prior to occupancy. 2015 IFC, Section 906 33. Service Stations-A fire extinguisher with a minimum U.L. rating of 2-A:20-B:C shall be provided and so located that it will not be more than 75 feet from any pump, dispenser or fill-pipe opening. 2015 IFC, Section 2305.5. Fueling station must meet requirements of Chapt. 23 of the International Fire Code Section 2304.3 2015 edition 34. Fire Alarm System -An approved automatic fire detection system shall be provided as required by City Ordinance No. 3021-07, Chapter 16.76, of the Everett Municipal Code. Plans for such system shall be submitted to the Fire Code Official for review and approval prior to installation. Submittal shall include cut sheets of all equipment intended for use. Appropriate trip tests, witnessed by a Fire Department Inspector, shall be performed, along with a certificate of completion, prior to final acceptance of the system. Fire alarm systems shall be installed according to NFPA Chapter 72, 2013 Edition. Installation of fire alarm components, including basic wiring, may not commence before plans are approved by the Fire Department Plan Reviewer. Fire alarm drawings must be professionally rendered, in sufficient detail, and must be internally consistent. Riser diagrams must match installation plans and load calculations. Components must be listed and approved for use together. Changes to plans must include new drawings and calculations and must be approved by the Fire Department Plan Reviewer prior to installation. Fire alarm installation is subject to field inspection by a Fire Department Inspector. An approved set of plans and the Engineering & Public Services Department electrical permit must be present for any installation inspection. Fire alarm systems shall be installed under permit of the City of Everett Engineering & Public Services Department. Electrical inspections and approval are required prior to calling for acceptance tests. Call (425) 257- 8810 for permit information. The absence of monitoring for the alarm system will be cause for postponing Fire Department inspection and testing and shall result in denial of occupancy. A copy of NFPA 72 Record of Completion form must be filled out prior to final occupancy(NFPA 72, 2013 Edition, Chapter 7, pages 107-147). 2015 IFC, 907.7.2 Call for design requirements per Authority Having Jurisdiction. Automatic smoke detection is required. N