Laserfiche WebLink
Insulation Certificate for Residential New Construction <br />Permit #: <br />House address or lot number: Harrison Lot 18 Unit R- 9502 18th <br />Walls <br />Type of insula ion: Fiberglass <br />Manufacturer O.C. <br />R-Value: 21 <br />Floor <br />Type of insulation: <br />Manufacturer: <br />R-Value: 38 <br />Flat Ceiling/ <br />Type of insulation: <br />Manufacturer: <br />R-Value: 49 <br />Single Rafter <br />Type of insulation: <br />Manufacturer: <br />R-Value: <br />Fiberglass <br />O.C. <br />Attic <br />Fiberglass <br />O.C. <br />Joist Vaulted Ceiling <br />Insulation Installer: <br />Company Na <br />Signature: <br />Phone Numbed / 425.233. <br />Washington State <br />R303.1 Identificatior <br />303.1.1 Building <br />sulation <br />Blown or Sprayed Fiberglass or Cellulose — Walls <br />R-Value per Inch: <br />Coverage Area: <br />Bag Count: _ <br />Blown or Sprayed Fiberglass or Cellulose — Ceiling <br />R-Value per Inch: 3.3 <br />Coverage Area: — 45 <br />Bag Count: <br />Sprayed Polyurethane Foam (SPF) <br />Density: <br />Installed Thickness: <br />R-Value of Installed Thickness: <br />Building Component Installed: walls floor ceili <br />Admin: Stesha Kirk <br />Date: 3.13.24 <br />.nergy Code Reference htt�:[Jww_energy.wsu.edu/Documents/2012%2oRes%Z,OE !grgy.pdf : <br />Materials, systems and equipment shall be identified in a manner that will allow a determination of compliance with the <br />applicable provisions of this code. <br />nal envelope insulation. An R value identification mark shall be applied by the manufacturer to each piece of building thermal <br />envelope insulation 12 inches (305 mm) or greater width. Alternately, the insulation installers shall provide a certification listing the <br />type, manufacturer and R-value of insulation installed in each element of the building thermal envelope. For blown or sprayed <br />insulation (fiberglass and cellulose), the initial installed thickness, settled thickness, settled R-value, insulation density, coverage area <br />and number of bags installed shall be listed on the certification. For sprayed polyurethane foam (SPF) insulation, the installed <br />thickness of the areas covered and R-Value of installed thickness shall be listed on the certification. The insulation installer shall <br />sigh, date and post certification in a conspicuous location on the job site. <br />