Faber Construction Corporation 4/23/2025

CITY OF EVERETT SPECIAL PROVISIONS LS47-Beverly Lake Sewer Replacement Division 1 – GENERAL REQUIREMENTS January 30, 2025 WO No – UP3529 SP – 60 Assistants and inspectors may advise the Contractor of any faulty work or materials or infringements of the terms of the Contract; however, failure of the City’s Representative or the assistants or inspectors to advise the Contractor does not constitute acceptance or approval. 1-05.3 Working Drawings Revise the second paragraph to read as follows: 1. Type 1 – Submitted for City information. Submittal must be received by the City a minimum of 7 working days before Work represented by the submittal begins. 2. Type 2 – Submitted for City review and comment. Unless otherwise stated in the Contract, the Engineer will require up to 15 working days from the date the Working Drawing is received until it is returned to the Contractor. The Contractor shall not proceed with the Work represented by the Working Drawing until comments from the Engineer have been addressed. 3. Type 2E – Same as a Type 2 Working Drawing with Engineering as described below. 4. Type 3 – Submitted for City review and approval. Unless otherwise stated in the Contract, the Engineer will require up to 20 working days from the date the Working Drawing is received until it is returned to the Contractor. The Contractor shall obtain the Engineer’s written approval before proceeding with the Work represented by the Working Drawing. 5. Type 3E – Same as a Type 3 Working Drawing with Engineering as described below. Supplement 1-05.3 as follows: The Contract Documents include Plans that show such details as are reasonably necessary to give a comprehensive understanding of the Work. The Contractor shall submit alterations affecting the requirements and information in the Plans in writing to the Engineer for approval prior to performing such Work. The Engineer may supplement the Plans with additional drawings and explanations, consistent with the purpose and intent of the original Plans, to detail and illustrate the Work. The Contractor shall perform the Work according to these supplemental drawings and explanations. In addition to supplemental drawings furnished by the Engineer, the Contract Documents may also be supplemented by Type 1, Type 2 or 2E, and Type 3 or 3E Working Drawings prepared by the Contractor, material supplier, or manufacturer, when necessary or as required by the Contract Documents to detail and illustrate portions of the Work. All types of Working Drawings shall be reviewed by the Engineer before work pursuant to those Working Drawings is performed. Type 3 and 3E Working Drawings may include, and not be limited to, shop details, erection plans, masonry lay-out diagrams, reinforcing steel and bending diagrams, post tensioning plans, shoring, cribbing, cofferdam, or falsework plans, formwork plans, or hydraulic items. Type 2 and 2E Working Drawings may include, and not be limited to, Catalog cuts or standard plans for commonly used manufactured items. The Contractor shall be fully responsible for the accuracy of dimensions and details on Working Drawings, and for complete conformity with the Contract Documents, even if the Working Drawings have been approved by the Engineer, or if the Contractor and the Engineer agree on dimensions and details. The City does not accept Working Drawings as accurate or adequate, and does not take responsibility for, or warrant that Working Drawings will meet Contract requirements. Engineer's review of Working Drawings shall not relieve Contractor from responsibility for variation from the requirements of the Contract Documents unless Contractor has in writing called the Engineer's attention to each such variation at the time of submission,