Laserfiche WebLink
2018 WSEC Requirements for Commercial Buildings including Group R2, R3 & R4 over 3 stories & all R1 -- Administered by ©2024 NEEA, All rights reserved <br />The following information is necessary to check a permit application for compliance with the lighting systems, motors and electrical system requirements in the <br />Washington State Energy Code, Commercial Provisions. <br />For questions about this report, contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br />-=A C405.2.1.2 Occupant sensor Indicate each aisleway and corridor within a <br />controls - warehouses warehouse space are designated as separate <br />spaces zones that are independently controlled <br />NA Indicate occupant sensors are configured to <br />automatically reduce lighting power by 50% <br />when the zone is unoccupied and 100% off <br />after the zone is unoccupied for over 20 <br />minutes; indicate controls are configured to <br />automatically restore lighting to full power <br />when the zone or space is occupied <br />NA C405.2.1.3 Occupant sensor For open plan office areas larger than 300 sf, <br />controls - open plan indicate general lighting is provided with <br />office areas vacancy controls that reduce lighting power by <br />not less than 80% and are configured to turn <br />luminaires 100% off when the space is <br />unoccupied; indicate that no individual control <br />zone area exceeds 600 sf <br />C405?_1A Occupant Nensor Indicate parking garage general lighting is <br />controls - parking provided with vacancy controls that reduce <br />rnzllea lighting power by not Icss than ?07r and are. <br />configured to turn luminaires 100% off when <br />no vehicles or pedestrians are present, unless <br />eligible I or an exception: indicate that no <br />individual control zone area exceeds ',,600 sf <br />NA <br />C405.2.1.5 Occupant sensor <br />Indicate stairway lighting is provided with <br />controls - enclosed <br />vacancy controls that reduce lighting power by <br />fire -rated stairwells <br />not less than 50% when the stairway in <br />unoccupied <br />YES <br />C405.2.2.1 Automatic time <br />Indicate spaces on plans where time switch E Sheets <br />switch controls <br />controls turn luminaires 100% off during <br />unoccupied hours <br />YES <br />Indicate spaces on plans where time switch E Sheets <br />controls are configured to turn on lighting to <br />full power versus 50% power <br />YES <br />Indicate locations of override switches on E Sheets <br />plans and the lighting zone(s) served; indicate <br />that the area(s) served by each override switch <br />does not exceeds 5,000 sf <br />NA <br />C405.2.1, Digital timer switch <br />Indicate digital timer switch control includes: <br />Exception 3 <br />manual on/off, time delay, audible and visual <br />indication of impending time-out <br />NA <br />C405.2.4.2 Daylight zones - <br />Indicate primary and secondary sidelit <br />C405.2.4.3 Sidelit and toplit <br />daylight zone floor areas on plans <br />NA <br />Indicate toplit daylight zone floor areas on <br />plans <br />NA <br />For small vertical fenestration assemblies <br />(rough opening less than 10 percent of <br />primary daylight zone floor area) where <br />daylight responsive controls are not required, <br />provide fenestration area to daylight zone <br />floor area calculation(s) <br />Page 2110 <br />