Laserfiche WebLink
2018 WSEC Requirements for Commercial Buildings including Group 112 R3 & R4 over 3 stories & all Ri -- Administered by ©2023 NEEA All rights reserved <br />The following information is necessary to check a permit application for compliance with the lighting systems, motors and electrical system requirements in the <br />Washington State Energy Code, Commercial Provisions. <br />For questions about this report contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br />C405.6 <br />Electrical <br />Include electrical transformer schedule on <br />transformers <br />electrical plans; indicate transformer type, <br />I <br />size, efficiency, or exception taken <br />i <br />— <br />YES <br />C405.11 <br />Feeders and branch <br />Provide documentation that demonstrates <br />E Sheets <br />circuits <br />maximum voltage drop across feeders and <br />branch circuits does not exceed 5% <br />i <br />C405.7 <br />Dwelling unit <br />Indicate on electrical plans that each dwelling <br />j <br />electrical energy <br />unit in Group R-2 has a separate electrical <br />consumption <br />energy meter <br />i <br />C405.8 <br />Electric motor <br />Include all motors, including fractional hp <br />efficiency <br />motors, in electric motor schedule on <br />i <br />electrical plans; indicate motor type, <br />horsepower, rpm, rated efficiency, or <br />exception applied <br />C405.9.1 <br />Elevator cabs <br />For luminaires in each elevator cab, provide <br />calculations that demonstrate average efficacy <br />is not less than 35 lumens per watt <br />For elevators that do not have an integral air <br />conditioning system, indicate rated watts per <br />cfm for elevator cab ventilation fans do not <br />exceed 0.33 watts per cfm <br />Indicate automatic controls that de -energize <br />lighting and ventilation fans when elevator is <br />stopped and unoccupied for a period of 15 <br />minutes or more <br />C405.9.2 <br />Escalators and <br />Indicate escalators comply with ASME <br />moving walks <br />A17.1/CSA B44; automatic controls are <br />configured to reduce operational speed to the <br />minimum permitted when not in use <br />i <br />C405.9.3 <br />Regenerative drive <br />Indicate all one-way down or reversible <br />escalators are provided with a variable <br />frequency regenerative drive <br />DOCUMENTATION AND SYSTEM REQUIREMENTS TO SUPPORT COMMISSIONING (CX) <br />C408.4 <br />Scope of electrical <br />Indicate that all electrical systems <br />power and lighting <br />(receptacles, transformers, motors, vertical <br />systems <br />and horizontal transportation) for which the <br />commissioning <br />WSEC requires control functions and / or <br />configuration to perform specific functions <br />are required to be commissioned <br />Where total building lighting load is > 20 kW, <br />or where total lighting load of luminaires <br />requiring daylight sensing and / or occupancy <br />control > 10 kW, indicate that all automatic <br />lighting control systems are required to be <br />commissioned; or provide building lighting <br />power calculation demonstrating eligibility for <br />exception <br />C405.13 <br />Commissioning <br />Indicate Cx requirements in plans and <br />C408.1,1 <br />requirements in <br />specifications for all applicable electrical and <br />C408.1.2 <br />construction <br />lighting control systems per C408 <br />C408.I.4.2 <br />documents <br />C103.6.3 <br />Page 9110 <br />