Laserfiche WebLink
"SUGGESTED RECOMMENDATIONS WHEN USING <br /> CRIMPING SEALS" <br /> 1 . The strap must be identified "MINUTE MAN ANCHORS INC. CERTIFIED ANSI <br /> 225.1 AND ASTM D3953." <br /> 2. WHEN EXTENDING OR SPLICING TWO STRAPS, OVER LAP APPROX. 6", USE TWO <br /> SEALS FULLY CRIMPING EACH SEAL TWICE TO BOTH STRAPS. <br /> 3. WHEN STRAPPING TO AN APPLIANCE SUCH AS SLOT IN A VERTICLE TIE OR A <br /> HOOK OR A BUCKLE WE SUGGEST THAT YOU USE A SHORT PIECE OF STRAP <br /> (RADIUS CLIP) BENT 180 degrees IN DIRECT CONTACT WITH THE APPLIANCE. <br /> (This will act as a cushion, reinforce and prevent sharp bends in the strap.) <br /> NEXT INSERT THE STRAP BENDING IT OVER 180 degrees BACK TO THE STRAP <br /> USING ONE SEAL, PLACE BOTH STRAPS INTO SEAL AND CRIMP TWICE. <br /> 4. SEALS MUST ALWAYS BE CRIMPED TWICE, <br /> 5. PLEASE NOTE: TWO SEALS REQUIRED WHEN SPLICING TWO STRAPS. ONE SEAL <br /> WHEN BENDING 180 degrees. <br /> RADIUS CLIP - 3' to 6' o"'v wm sexy sou 113 <br /> Allh6 <br /> /,) <br /> � • w IN-MNSalaw r aim MINUTE MAN STRAP r/RADIUS CLIPRADIUS CLIP 1 1/4 x OA35GALV. STEEL STRAP.ZINC COATING MEETS ANSI 225.1 AND ASTM D3953 G60 <br /> SNAP-ON SEAL 1-1/4 x 0.035 x 2-3/16 <br /> ASTM D3953 <br /> MARK MMA <br /> Revised 3/14/07 18. <br />