Laserfiche WebLink
Mid <br />/ <br />--_- Washington State Energy <br />These requirements apply 10all |RCbuilding types, including detached one- and two-family <br />dwellings and multiple single-family dwellings , ' <br />�Du�plex Napa Homes LLC <br />Instructions: This ngle-fawill use the requirementsufthePresuiptivePothbe|ovvend <br />incorporate the minimum values listed. Based on the size of the structure, the appropriate number of <br />additional credits are checked aschosen 6xthe permit applicant. <br />Provide all information from the following tables as building permit drawings: Table R402.1 - Insulation and <br />Fenestration Requirements by Component, Table. R406.2 - Fuel Normalization Credits and 406.3 - Energy Credits. <br />All Climate Z -ones (TableR402.1,1) <br />R-values are minimums. U-factors and SHGC are maximums. When insulation is installed in a cavity that is less <br />a <br />than the label or design thickness ofthe insulation, the compressed R-value ofthe insulation from Appendix <br />Table A101.4 shall not be less than the R-value specified in the table. <br />b <br />The fenestration U-factor column excludes skylights. <br />"10/15/21 +5TB" means R-10 continuous insulation on the exterior of the wall, or R-15 continuous insulation on <br />the interior of the wall, or R-21 cavity insulation plus a thermal break between the slab and the basement wall at <br />c <br />the interior of the basement wall. "10/15/21 +5TB" shall be permitted to be met with R-13 cavity insulation on <br />the interior of the basement wall plus R-5 continuous insulation on the interior or exterior of the wall. "5TB" <br />means R-5 thermal break between floor slab and basement wall. <br />d <br />R-10 continuous insulation is required under heated slab on grade floors. See Section R402.2.9.1. <br />For single rafter- orjoist-vaulted ceilings, the insulation may be reduced to R-38 if the full insulation depth <br />e <br />extends over the top plate of the exterior wall. <br />R-7.5 continuous insulation installed over an existing slab is deemed to be equivalent to the required perimeter <br />f <br />slab insulation when applied to existing slabs complying with Section R503.1.1. If foam plastic is used, it shall <br />meet the requirements for thermal barriers protecting foam plastics. <br />For log structures developed in compliance with Standard ICC 400, log walls shall meet the requirements for <br />9 <br />Int. (intermediate framing) denotes framing and insulation as described in Section A103.2.2 including standard <br />h <br />framing 16 inches on center, 78% of the wall cavity insulated and headers insulated with a minimum of R-10 <br />RD [V�EME <br />NOV - 9 2023 <br />���T���������T� <br />~"'^` ^~' ~-'—'—'' <br />Preoonpt*apom-amglepamily uo1aWashington State Energycouo-R <br />