Laserfiche WebLink
b. Show on the plans the excavation, shoring, and restoration for removing the existing street light <br />pole and foundation and installing the proposed street light pole with deeper foundation. <br />Trench and road/sidewalk restoration must be called out per City of Everett Standards with <br />specific name and standard drawing number per the Design and Construction Standards <br />Manual: https://everettwa.gov/1531/Design-Construction-Standards. <br />3. The comments below were generated from this project's Traffic Engineering Reviewer. If you have any <br />questions regarding these comments, please contact Corey Hert with City of Everett's Traffic Engineering <br />Division (425-257-8887 or CHert@everettwa.gov). <br />a. Please specify the finish of the replacement street light poles (mill finish, powder coated, <br />anodized, etc.). The City's preference is mill finish for all new poles. <br />As the plans are specified with (3) 2" conduits and (1) 4" conduit, that will not fit in the pole <br />diameter that is specified. The pole also requires welded partitions. <br />i. Show a detail of the foundation with conduit stubs up into the partitions. The wires can <br />continue up the pole within the partitions without conduit. The detail shall identify the <br />conduit sizes and what each partition shall be used for, with City of Everett's street light <br />wire as the partition closest to the side of the pole that the luminaire arm is attached to <br />in order to feed the luminaire. <br />c. Provide details for the connection of the City street light into the City lighting circuit through the <br />pole foundation. <br />d. Detail A on the Valmont plans shows breakaway couplings on the foundation. These are not <br />used in the City of Everett. See Everett's pole base standards, showing it bolted directly to the <br />anchor bolts. <br />e. On the Valmont plans, the hand hole shown at the top of the pole by the luminaire arm needs to <br />be located on the same side as the luminaire arm in order to pull wire to the luminaire. <br />f. Remove banners from the pole on the Hewitt Site. These are no longer used. <br />g. Provide shop drawings for the poles. <br />h. Details 4 and 5 on page G-1 need to be revised. The City does not allow overhead feeds to the <br />street light poles. All poles must have underground services for power and data. <br />i. Show the cabinet for power service on the plans. <br />ii. Show the disconnect at your service location. <br />M. Show on the plans the trenching and pavement restoration for power and data service. <br />O3200 Cedar Street O 425.257.8810 © everetteps@everettwa.gov <br />Everett, WA 98201 425.257.8857 fax everettwa.gov/permits <br />Page 2 of 3 <br />