Laserfiche WebLink
The comments below were generated from this project's City of Everett Traffic Engineering Reviewer. All questions shall be routed through this project's <br />Public Works Reviewer Thad Newport with City of Everett Permit Services (TNewport(cDeverettwa.gov). <br /># <br />Document <br />Sht/Pg <br />Reviewer's Comment <br />Designer's Response <br />Initials <br />5. Please add a note that vaults called out in these sheets shall <br />have non-skid lids and meet ADA gap acceptance requirements <br />called out on sheet T3. <br />6. References to the IL & TS sheets have been <br />6. Please show all of the work being done on the IL and TS sheets <br />added to the A -Sheets <br />on this sheet including but not limited to the service cabinet <br />being installed as well as the conduit runs into the existing signal <br />junction boxes, and the traffic signal loops to ensure there are <br />no conflicts in this work area. <br />7. 22x12x12junction box that conflicted with IL1 <br />7. Please remove the information about the proposed 22x12x12 <br />and TS1 has been removed and replaced with a <br />junction COE junction boxes and show the information that is on <br />22x12x12 junction box that matches the IL1 and <br />the IL1 and TS1 on this sheet to properly show the tie ins to the <br />TS2 SoW. <br />COE illumination system. <br />8. Please show the existing pole being removed with its <br />8. Existing pole is called with all additional <br />foundation being removed entirely and conduits cut off 24" <br />stipulations included. <br />below grade. <br />9. Please show the new pole being installed in line with the old <br />9. New pole is now location 10' south from its <br />pole but approximately 5-10' to the north to clear the existing <br />original position. <br />foundation and to move the new small cell pole further away <br />from our existing COE signal pole and equipment. <br />10. requested note has been added <br />10. Please add a callout to the existing illumination run heading <br />north saying "(E) Direct -Buried Wire (Approximate Location, <br />Contractor to field verify)" <br />4 <br />A-3 <br />1. Please make the information shown on the A series sheets <br />1. A -sheets have been revised to corroborate <br />corroborate with the pole shop drawings, and the work being <br />with pole shop drawings, IL, & TS sheets. <br />done on the IL and TS sheets. Comments 2-5 explicitly deal with <br />Changes have been clouded & delta'd. <br />making sure no conflicting information is being shown in <br />different sheet series. <br />2. Complete Valmont poles drawings provided. <br />2. The existing pole has a 30' luminaire mounting height as <br />This site will specifically use Pole Item #10, 12' <br />shown on this sheet, however the Valmont pole shop drawing is <br />luminaire arm with a 30' fixture mounting <br />calling for a luminaire mounting height of 35'. Please submit <br />height. <br />complete Valmont pole and luminaire arm shop drawings for a <br />3-4. The cabinet enclosure is not being provided <br />pole with 30 mounting height. <br />by Valmont thus it would not be shown in their <br />Page 4 of 10 <br />