Laserfiche WebLink
Note: Prior to installation, refer to any local, state and federal regulations, to assure proper compliance, <br /> Soil test probe the anchor location in order to match the soil classification with the proper anchor. <br /> '114ate 'anchors° inc- <br /> / <br /> Warning: Before ground anchor installation, <br /> ANCHOR INSTALLATION determine that the anchor locations around home will <br /> There are two basic methods of installing not be close to any underground electrical cables, <br /> anchors, each equally effective in properly water lines or sewer piping. Failure to determine the <br /> securing manufactured homes to the ground. location of electrical cables may result in serious <br /> CAUTION: The installation of anchors with a personal injury. <br /> drive machine is a two person operation. <br /> MACHINE INSTALLATION MANUAL INSTALLATION <br /> In this method, the anchor is turned to A hole is dug to a depth <br /> full depth into the ground by an anchor of approximately '/2 the <br /> drive machine. length of the anchor, in <br /> the proper position as <br /> Attach anchor to explained under machine <br /> 8`O� machine. 1A installation. <br /> / I�`L p After the hole is dug to '/2 <br /> e the length of the anchor, <br /> • then the anchor is turned <br /> 2. Placed anchor in proper �� into the ground by hand, <br /> position in line with strap using a rod or length of <br /> µAU 4 a and machine. pipe for leverage or by <br /> 3 w <br /> ". ' machine. <br /> 10 <br /> 3. __ Anchor should be installed After anchor is installed <br /> at a slight angle as shown full depth, earth is <br /> to assure head being repacked, six inches at a <br /> positioned behind future <br /> skirting. time. <br /> PROPER TENSIONING OF STRAP TO ANCHOR HEAD <br /> Insert bolt into head; attach nut Bend strap 90°and take at least <br /> loosely. Insert strap in slot of three complete turns on bolt until <br /> 5/8" bolt until strap is flush with i (r ��/) strap is taut. <br /> far side of bolt. IN <br /> 1. 2. <br /> Bolt is turned with 15/16" socket wrench, or adjustable wrench, on <br /> hex head. With square hole in anchor head, hold bolt under tension <br /> while repositioning wrench: Place open-end wrench on 5/8" square <br /> shoulders of bolt. Align square shoulders of bolt with square hole in <br /> 3. anchor head. <br /> Holding hex head of bolt in position, tighten nut to draw square shoulders into square <br /> UIhole. Shoulders are now in locking position; continue to tighten nut. Tensioning device <br /> — ` is now in lkd, t <br /> Note: The tensioningoce boltsecure canposi beion.inserted in the head from either side. <br /> Notice: In areas of severe cold weather, where possible damage could occur from frost heave, <br /> 4, the homeowner should be prepared to adjust tension on the straps to take up slack. <br /> 1. <br />