11311 19TH AVE SE CLUBHOUSE 2025 Plans 2025-09-16

City of Everett Permit Services EVERETT Reviewed for Permit 01/30/2025 Painting If desired finishing includes a painted wall, a high-quality 100% acrylic latex paint with a high-quality latex primer STEEL STUD base coat are recommended around the appliance to limit SIDE VIEW discoloration. Oil-based or standard acrylic paints may be more prone to discoloration due to heat exposure. MASONRY ' 12 in. �-- WALL Drywall Joint-Crack Prevention and Repair MAXIMUM Drywall joints around the fireplace will be affected by ex- FACING posure to elevated temperatures, along with other envi- ronmental, structural factors due to new construction, and methods used to install and finish the drywall. If a crack does emerge adjacent to the fireplace, it can be perma- END VIEW s nently repaired by filling it with a paintable latex caulk, END VIEW ' followed by repainting. SEAS_ Some movement of the screws used to secure the non- TRANSITION combustible board to the appliance/surround framing is expected. If a blemish begins to show over a screw head, sand the surface to remove the blemish and repaint. APPLIANCE NOTE: Concealed sections of 3 in.flex pipe must be contained inside existing masonary fireplace flue vent or installed into an existing wood burn- ing vent system. Figure 3.12 Transition Sealing Detail for Wall Extensions(Side View) Wall Extension Wall extension must be sealed to existing masonry wall. See Figure 3.12. Framing studs may not sit flush against existing masonry wall. In order to keep heat from escaping behind the wall this transition must be sealed. • Seal with a high temperature silicone 300 °F. and /or • Packing insulation into voids between the masonry wall and steel studs is acceptable. Note: Combustible materials may be used to seal wall extension to existing masonry wall as long as it is out- side the non-combustible zone. 16 Heat&Glo • SUPREME-125-IFT,SUPREME-130-IFT,SUPREME-135-IFT Installation Manual 2532-980 Rev. F 5/19