Laserfiche WebLink
City of Everett Permit Services <br /> EVERETT Reviewed for Permit 01/30/2025 <br /> WP5X11 <br /> 1 <br /> iON E. Connecting Vent Pipe <br /> Reference instructions in the termination kit. <br /> • Install the 3 in. flexible vent pipe(s) down through the <br /> chimney. <br /> • Secure the exhaust flexible vent pipe to the exhaust <br /> starting collar on top of the appliance with three screws. <br /> See Figure 5.1. <br /> For best results in cold climate be sure 3 in. flex is flush <br /> and tight to the collar slide plate assembly. Seal with <br /> stove cement or aluminum foil tape. Do not use silicone. <br /> • Use 3 screws to attach the section of inlet air vent to the <br /> inlet air starting collar on the collar slide plate assembly. <br /> See Figure 5.1. NOTE: The collar slide plate assembly <br /> may be removed from appliance to aid installation and <br /> service. <br /> For best results in cold climate be sure 3 in. flex is flush <br /> and tight to the collar slide plate assemby. Seal with <br /> stove cement or aluminum foil tape. Do not use silicone. <br /> CUT AND BEND <br /> FLASHING AS NEEDED <br /> TO FIT CHIMNEY <br /> O <br /> SEALANT <br /> ADHESIVE <br /> a <br /> a <br /> Figure 5.6 <br /> • Trim chimney top plate to minimize excess overhang or <br /> bend over flue tile. See Figure 5.6. <br /> • Place 3/8 inch bead of 300 °F minimum continuous <br /> exposure rating silicone on flue tile top. <br /> Heat&Glo • SUPREME-125-IFT,SUPREME-130-IFT,SUPREME-135-IFT Installation Manual 2532-980 Rev. F 5/19 25 <br />