2523 STATE ST 2026-01-06 - Laserfiche WebLink

CITY OF EVERETT EVERETT Public Works Department WASHINGTON Date: February 24, 2022 Owner: Julie and Michael Larson Job Address: 2523 State St. Everett, WA 98201 Plan Check No: B2202-009 Email Address: ak08propertiesllc@yahoo.com RE: Building Submission Intake Letter Dear Julie and Michael Larson, In response to the application for a building permit,the plans have been examined and you are advised that revisions are required before a review may begin. Please review and respond to the comments below. 1. The submitted documents include sketches for the proposed project. Construction-level drawings prepared using established drafting standards are required to substantiate compliance with the IRC. Prepare drawings using the approved scales. Use consistent scales where appropriate (e.g., same scale for all architectural and structural plans, etc.). Scales should be: Architectural and Structural plans: architectural scale (e.g., %" = V-0", etc.). 2. Smoke and CO alarms should be provided per IRC Sections R314 and R315. The locations of all alarms should be shown on the plans. The alarms should be hardwired, interconnected, and provided with back-up battery power as required. 3. The project includes exposing the exterior envelope cavities for the entire building. The building is required to be insulated per WSEC Section R503.1.1. Where required, insulation complying with current code should be provided per Table R402.1.1. Attics should be provided with ventilation baffles per Section R402.2.3. 4. The project includes replacement of the existing windows and exterior doors. The required thermal ratings for each type of vertical fenestration should be specified. See WSEC Table R402.1.1. 5. The proposed project includes the demolition of non-bearing walls specified on Sheet 2. The ceiling framing plans on Sheets 7 and 8 show an interior bearing wall but Sheet 2 specifies non- load bearing. Framing plans for ceiling,and roof should be provided to substantiate that the walls are not load-bearing or show the modified load path complies with the prescriptive limitations of the IRC. Alternatively, an engineered analysis and design may be performed per IRC Section R301.1.3; sealed and signed drawings and calculations prepared by a professional engineer licensed in the state of Washington are required per RCW 18.43.010, 18.43.020, and 18.43.070. The framing and foundation plans, and structural calculations as required, should show a complete load path. See IRC Section R301.1. The plans should also include a note 3200 Cedar Street © 425.257.8810 O PermitServices@everettwa.gov Everett,WA 98201 everettwa.gov/permits