KLB Construction 6/22/2016 - Laserfiche WebLink

EVERETT TYOF I SPECIAL PROVISIONS To detail and illustrate the Work, the City's Representative may furnish to the Contractor additional drawings and explanations consistent with the original Plans. The Contractor ' shall perform the Work according to these additional drawings and explanations. The City's Representative may appoint assistants and inspectors to assist in determining that the Work and materials meet the Contract requirements. Assistants and inspectors have the authority to reject defective material and suspend Work that is being done improperly, subject to the final decisions of the City's Representative or, when appropriate, the City. Assistants and inspectors are not authorized to accept Work, to accept materials, to issue instructions, or to give advice that is contrary to the Contract. Work done or material furnished that does not meet the Contract requirements shall be at the Contractor's risk and shall not be a basis for a Contract Claim even if the inspectors or assistants purport to change the Contract. Assistants and inspectors may advise the Contractor of any faulty work or materials or infringements of the terms of the Contract; however, failure of the City's Representative or the assistants or inspectors to advise the Contractor does not constitute acceptance or approval. 1-05.3 Plans and Working Drawings Delete all of 1-05.3 and substitute the following: After Award of the Contract, the Contractor will receive up to six (6) sets of the reduced Plans (11" x 17") and accompanying Special Provisions. In addition, the Owner will supply up to three (3) sets of full size plans (22" x 34"). All Plans and Special Provisions will be conformed with addenda unless Contractor requests otherwise. Additional Plans and Special Provisions may be purchased by payment of the current printing costs. The Contract Documents include Plans that show such details as are reasonably necessary to give a comprehensive understanding of the Work. The Contractor shall submit alterations affecting the requirements and information in the Plans in writing to the Engineer for approval prior to performing such Work. The Engineer may supplement the Plans with additional drawings and explanations, consistent with the purpose and intent of the original Plans, to detail and illustrate the Work. The Contractor shall perform the Work according to these supplemental drawings and explanations. In addition to supplemental drawings furnished by the Engineer, the Contract Documents may also be supplemented by shop drawings prepared by the Contractor, material supplier, or manufacturer, when necessary or as required by the Contract Documents to detail and illustrate portions of the Work. Shop drawings shall be reviewed by the Engineer before work pursuant to those shop drawings is performed. Shop drawings may include, but not be limited to, shop details, erection plans, masonry lay-out diagrams, reinforcing steel and bending diagrams, post tensioning plans, shoring, cribbing, cofferdam, or falsework plans, formwork plans, or hydraulic items. Catalog cuts or standard plans for commonly used manufactured items will be considered as shop drawings. Unless otherwise requested by the Engineer, the Contractor shall submit six (6) hardcopies of complete sets of shop drawings or one electronic set in either PDF or DWG formats directly to the Engineer for review and approval. If the design engineer _ is a full time employee of the City, the Contractor may expect fourteen (14) calendar SEWER SYSTEM REPLACEMENT AND CAPACITY IMPROVEMENTS SEWER"M" PHASE II WO No.- UP3470-10 Division 1 -GENERAL REQUIREMENTS April 2016 SP-79 I