Alpine Waterproofing 8/23/2016 - Laserfiche WebLink

I POLICE HQ—MASONRY CLEANING AND REPAIR APRIL 15,2016 of Labor and Industries. Current flagging cards from Oregon and Idaho are also acceptable. The flagging card shall be immediately available and shown to the Owner upon request. 3) Workers engaged in flagging or traffic control shall wear reflective vests and hard hats. During hours of darkness,white coveralls or white or yellow rain gear shall also be worn. During hours of darkness flagger stations shall be illuminated to ensure that flaggers can easily be seen without causing glare to the traveling public. The Contractor shall furnish the MUTCD standard Stop/Slow paddles (18 inches wide, letters 6 inches high and reflectorised)for the flagging operations. b. High Visibility Apparel and Equipment: 1) The Contractor shall furnish for the use of flaggers,reflective vests I and hard hats for the flagging and control of traffic. This equipment shall be used by the flaggers while actually flagging traffic. The Contractor shall also provide any such equipment used that is necessary or desirable to protect personnel engaged in other activities. 2) The Contractor shall require all personnel at the work site under , their control(including Subcontractors and lower tier Subcontractors)to comply with the following: a) To wear reflective vests,except that during daylight hours, orange clothing equivalent to "Ten Mile Cloth" or hunter orange may be worn in lieu of reflective vests b) To wear white coveralls at night c) Whenever rain gear is worn during hours of darkness,it shall be white or yellow. d) The reflective vests shall always be the outermost garment. 3) Reflective vests shall have a minimum of 100 square inches of reflective surface distributed 30 percent on the front and 70 percent on the back. The retro-reflection value at an entrance angle of-4 degrees and an observation angle of 0.2 degrees shall be a minimum 500 candle power for the reflective surface of the vest. Reflective vests,hard hats,white coveralls,rain gear,and other apparel shall be furnished and maintained in a neat, clean,and presentable condition at no additional cost to the Owner. 1 2. Traffic Control Vehicles: a. The traffic control vehicle shall be equipped with a roof or post mount flashing amber light visible for 360 degrees. Truck and construction Equipment that encroaches onto the traveled Roadway for any reason shall also be equipped with flashing yellow warning lights. Unless one or more flagmen are present to control traffic, supplementary traffic control devices shall be placed to warn, slow down,and if necessary divert traffic around such Equipment. 3. Construction Signs: a. General 1) The Contractor shall furnish,install and maintain all traffic control signs required by the Contract or a Contractor's approved traffic control plan. These include: a) Temporary traffic control signs. VEHICULAR ACCESS AND PARKING 01 5500 - 10 I