3616 ROCKEFELLER AVE 2016-10-04 - Laserfiche WebLink

A#tachment of �rac�et Covers, Skirts, and Caps: 1. Attach corresponding bracket covers over the opening in the upper and bott�m rails. 2. Atta.ch pravided post skirt to th� bottom of the po�ts. 3. Attach post caps to sta.ndard posts {use of rubber �a�lei �nay be required for secu.re attachment}. At�act�ment oi Footblock (itet�uired ON�.Y for AI1 Clear Span A�plicatians �ver 6`): 1. Attach foat block under the center of the bottom rail. Begin by attaching the base of the faotblock by screwing the angled screv✓ into the base and inta the decking. After attached, slide the footblock onto th� base until it locks into place_ Stair Railin� In�tallataan: NO�'��: � All Reveal stair i�zstal�ations reqa�ire the use of 5399 sta�r post, m�asured and cut to ap�rograate (ength. • If crossover staar post is required, use s�air post (again cut to appropriat� length} and use swivel crassover bracket. 1. Identify top and bottom stair rails. 2. Lay bottom rail on steps beside posts with even spacing between baluster holes at each end of pasts. Mark raiis at posts %r �ttin�. �ut rails 1/4" sht�rter than the mark on each end. 3. Positian bottom rail 1" above the nose of the steps (use a 1" spacer) and mark where the brackets are to be attached to the post. Attach bracket with self tapping screws (provided}_ 4. Measure and if required, cut balus�ers so that required stair height is achieved. If cutting balusters at an angle, measure angle of stairs and cut each end of the batusters at the same angle as top and bottom rails were cut, making sure the overall length of the balusters does nat change_ 5_ Insert balusters into bottom rail so balusters are fully seated into bottam raiL +GENTLE tapping with a rubber maltet may assist insertion. E�. Insert balusters into the top rail by starting at the top end and working towards the bottam of stairs. 7. Ensure that top rai3 is fully seated onto balusters, then attach top stair bracket to post based on this Iocation_ Attach top stair ra.il to post using self-tapping screws (provided). 8. Attach stair rail to brackets by inserting the self ta.pping screws (provided) in the side of the brackets. Li ;htly tap bracket covers onto the bracket. Use caution when insta.11ing brackets by applying pressure directiy on top of the bracket tab. 9. Attach skirts t� the bottom of posts. Crossove�- St�irs; I. Far crassover stairs, angle top crossover unit io match the angle of the stair and cut accordingly. 2. All other steps are the same as above. YageS REIIEAL-12'!2