Faber Construction Corp 9/27/2016

1 CITY OF EVERETT SPECIAL PROVISIONS Provide materials meeting the requirements of the following sections: Saddles 9-30.6(1) Special Provisions Corporation Stops 9-30.6(2) Special Provisions Service Pipe 9-30.6(3) Special Provisions Service Fittings 9-30.6(4) Special Provisions Meter Setters 9-30.6(5) Special Provisions Meter Boxes 9-30.6(7) Special Provisions Brass Nipples and 9-30.6(8) Special Provisions Fittings 7-15.3 Construction Requirements Revise the first paragraph in 7-15.3 to read as follows: Provide new service connections to new water mains using specified saddles of the size and type suitable for use with the service pipe being installed. Install new service connection piping from the main to the meter box as shown on the Plans and directed by the City Inspector. Install service connection piping perpendicular to the main, unless shown otherwise on the Plans or directed by the City Inspector. Revise the first sentence of the second paragraph in 7-15.3 to read as follows: Provide trench depth adequate to maintain a minimum of 30-inches of cover over the top of the connecting service pipe. Supplement 7-15.3 by adding the following: ' Provide service connections to water mains in accordance with COE Standard Drawings No. 502A, 502B and 502C as applicable. Field verify actual service connection location, size and material as existing service , information and locations shown on the Plans may not be accurate since this information is taken from existing records. Match the service size of the existing service connection with the minimum service size being 3/4-inch. Should the planned ' location require moving after verifying actual service connection in field, City Inspector and the City Utility Department personnel will make final decision as to its relocation. Replace existing services from the main to the property line, including the meter box ' and meter setting if noted on the Plans. Bore service connection lines, regardless of size, under pavement section, curbs and sidewalks where soil conditions and other existing buried utilities allow. The City inspector will allow open-cut trench installation across pavement section, curbs and sidewalks only where soil conditions prohibit boring. Open—cut lawn areas and other non-pavement areas for service installation unless City Inspector directs otherwise. The City Inspector may, at the Contractor's request, allow tunneling under curb and sidewalk as long as it appears no structural damage will be done to curb or sidewalk as a result of the tunneling operations. Regardless of the method used, the Contractor shall maintain a minimum of 30-inch cover over the service connection line. Where open cut trench installation is allowed, keep the trench width to 24-inches or less. Provide Controlled Density Fill for the full depth of backfill when open cutting streets. At existing metered services noted for removal or replacement on the Plans, salvage existing meter and stockpile on-site at location approved by City Inspector. Notify City Inspector 24-hours prior to removal to allow City Inspector to document the meter number and address of meter being removed. Remove and dispose of existing meter box, meter setter, fittings and service piping. Where existing metered services are not being replaced, backfill with native soil, compact and restore the surface to match existing condition. Water Main Replacement"Q" Division 7—WATER MAIN July 8, 2016 -Broadway WO No.—UP3612 SP-160