Faber Construction Corp 9/27/2016

CITY OF EVERETT SPECIAL PROVISIONS 8-14.3(3)A Curb Ramp Install Curb Ramp Type A, B, C, or D as the case may be at locations shown on the Plans. ' Construct the gutter grade the width of the detectable warning surface to maintain existing drainage and at a grade of less than 2%. Construct monolithic depressed curb and sidewalk as indicated on COE Standard Drawing No. 310A, 310B, 310C, 310D, and 311. Construct curb ramps separate from the sidewalk to produce a definite break line between the ramp and the sidewalk. Install a 3/8-inch non-extruded through joint material between the curb ' and the sidewalk with edging as specified in Section 8-14.3(3). Brush-finish the triangular shaped sidewing areas with brushing direction being perpendicular to the curb face. Brush-finish the landing area with brushing ' direction parallel to the detectable warning surface. Do NOT extend the adjacent sidewalk. Provide concrete for curb ramps that is not colored, overlaid or topped. Consider ' the curb ramps as beginning at a point flush with the gutter flowline and terminating at a point flush with the sidewalk landing. No lip shall be permitted at the junction of the gutter flowline and the curb ramp. Include the sloping triangular shaped sidewings as part of the curb ramp. ' 8-14.3(4) Curing Maintain sufficient protective covering on—site, such as waterproof paper or plastic membrane, to cover an entire day's pour in event of rain or other unsuitable weather. ' Protect the concrete sidewalk against damage or defacement until Owner has been accepted the Work. Remove and replace sidewalk that is not acceptable to the Engineer because of damage or defacement at Contractor's expense. ' After finishing, spray cement concrete sidewalk using transparent curing compound in accordance with 5-05.3(13)A of the Standard Specifications. 8-14.4 Measurement Delete all paragraphs in 8-14.4 and substitute the following: Bid items of Work completed pursuant to the Contract Documents will be measured as described in Division B - Bid Item Descriptions and Section 1-09 MEASUREMENT AND PAYMENT of the Standard Specifications. 8-14.5 Payment ' Delete all paragraphs in 8-14.5 and substitute the following: Payment for Bid items of Work completed pursuant to the Contract Documents will be as described in Division B - Bid Item Descriptions and Section 1-09 MEASUREMENT ' AND PAYMENT of the Standard Specifications. 8-20 ILLUMINATION, TRAFFIC SIGNAL SYSTEMS AND ELECTRICAL 8-20.3 Construction Requirements 8-20.3(1) General Supplement 8-20.3(1) by adding the following: ' Prior to cutting any loop detector wiring, give a minimum of 3 working days' notice to City of Everett's Traffic Department at 425-257-7296. 8-20.3(14) Signal Systems ' Supplement 8-20.3(14)C by adding the following: Water Main Replacement"Q" Division 8—MISC CONSTRUCTION July 8, 2016 -Broadway ' WO No.—UP3612 SP -169