Faber Construction Corp 9/27/2016

CITY OF EVERETT SPECIAL PROVISIONS 8-20.3(14)C Induction Loop Vehicle Detectors Induction loops shall be constructed as detailed in City of Everett Drawing Nos. 802A, 806, and Section 8-20.3(14)C of the Standard Specifications with the following modifications: 1) The loop locations shall be marked on the pavement by the contractor and approved by the engineer prior to sawcutting. At no point shall any of the sawcuts pass closer than 1' to any utility cover. 2) Loop detector sealant shall be on the QPL and also be approved by the Engineer. 3) Rope is not required. 4) Loops shall not be installed in rainy weather or at temperatures below 40°F. 5) Loops shall be placed in the sawcut in a clockwise direction. 6) The loop sealant shall be applied in accordance with the manufacturer's recommendations. 7) Loop wire shall be as shown on COE Standard Drawing 806. 8) The area around the conduit stub-out shall be patched with hot mix asphalt concrete if it is greater than 2" in width. 9) The sawcuts shall be of uniform depth and any sharp edges, abrasions or ridges shall be removed prior to placing the wire. 10) The sawcut depth shall be a minimum of 3W and shall provide a minimum of 2" cover above the loop wires. 11) The sawcut width shall be a minimum of 1/4" for the loop and 3/8" for the home run. 12) The sawcut shall be cleaned out with a high pressure water stream and then dried with compressed air prior to placing the wire. 13) All splices between the loop wire and the loop lead-in cable shall be soldered and utilize a Scotch Cast Epoxy 82-B1 splice kit in conformance with Standard Plan 806, 14) When the roadway is to be overlayed as a part of the project, the loops shall be installed prior to the final overlay. 15) Circular loops are standard installations. The Contractor may propose the use of square or rectangular loops for consideration by the Engineer. 8-20.4 Measurement Delete all paragraphs in 8-20.4 and substitute the following: Bid items of Work completed pursuant to the Contract Documents will be measured as described in Division B - Bid Item Descriptions and Section 1-09 MEASUREMENT AND PAYMENT of the Standard Specifications. 8-20.5 Payment Delete all paragraphs in 8-20.5 and substitute the following: Payment for Bid items of Work completed pursuant to the Contract Documents will be as described in Division B - Bid Item Descriptions and Section 1-09 MEASUREMENT AND PAYMENT of the Standard Specifications. 8-21 PERMANENT SIGNING 8-21.1 Description Supplement 8-21.1 by adding the following: Work involving installing traffic regulatory signs shall be in accordance with COE Standard Drawing 716 and street name signs in accordance with COE Standard Drawing 715 and 718 and as indicated on the Plans. Water Main Replacement"Q" Division 8—MISC CONSTRUCTION July 8, 2016 -Broadway WO No.—UP3612 SP-170