Ariston Pacific, Inc. 5/9/2016 - Laserfiche WebLink

I 1 compound. Bolts shall be installed snug tight. The bearing seat and lid perimeter shall 2 be machined to allow a minimum of 75 percent of the bearing areas to be seated with a 3 tolerance of 0.0 to 0.005 inches measured with a feeler gage. The bearing area 4 percentage will be measured for each side of the lid as it bears on the frame. 5 6 9-29.2(2) Standard Duty and Heavy-Duty Cable Vaults and Pull Boxes 7 This section's title is revised to read: 8 9 Small Cable Vaults, Standard Duty Cable Vaults, Heavy-Duty Cable Vaults, 10 Standard Duty Pull Boxes, and Heavy-Duty Pull Boxes 11 12 In the first paragraph, the first sentence is revised to read: 13 14 Small, Standard Duty and Heavy-Duty Cable Vaults and Standard Duty and Heavy-Duty 15 Pull Boxes shall be constructed as a concrete box and as a concrete lid. 16 17 9-29.2(2)A Standard Duty Cable Vaults and Pull Boxes 18 This section's title is revised to read: 19 20 Small Cable Vaults, Standard Duty Cable Vaults, and Standard Duty Pull Boxes 21 22 The first paragraph is revised to read: 23 24 Small and Standard Duty Cable Vaults and Standard Duty Pull boxes shall be concrete 25 and have a minimum load rating of 22,500 pounds and be tested in accordance with 26 Section 9-29.2(1)C for concrete Standard Duty Junction Boxes. 27 28 In the second paragraph, the first sentence is revised to read: 29 30 Concrete for Small and Standard Duty Cable Vaults and Standard Duty Pull Boxes shall 31 have a minimum compressive strength of 4,000 psi. 32 33 In the third paragraph, the first sentence is revised to read: 34 35 All Small and Standard Duty Cable Vaults and Standard Duty Pull Boxes placed in 36 sidewalks, walkways, and shared-use paths shall have slip-resistant surfaces. 37 38 The fourth paragraph (up until the colon) is revised to read: 39 40 Materials for Small and Standard Duty Cable Vaults and Standard Duty Pull Boxes shall 41 conform to the following: I 42 43 9-29.3 Fiber Optic Cable, Electrical Conductors, and Cable 44 This section is supplemented with the following new subsection: 45 46 9-29.3(3) Wire Marking Sleeves 47 Wire marking sleeves shall be full-circle in design, non-adhesive, printable using an 48 indelible ink and shall fit snugly on the wire or cable. Marking sleeves shall be made 49 from a PVC or polyolefin, and provide permanent identification for wires and cables. 50 51 9-29.3(2)A4 Location Wire 52 This section is revised to read: 1 AMENDMENTS TO THE 2014 STANDARD SPECIFICATIONS BOOK Revised: 8/3/15