Ariston Pacific, Inc. 5/9/2016 - Laserfiche WebLink

1 1 2 Working Drawings will be classified under the following categories: 3 4 1. Type 1 — Submitted for Contracting Agency information. Submittal must be 5 received by the Contracting Agency a minimum of 7 calendar days before work 6 represented by the submittal begins. 7 8 2. Type 2 — Submitted for Contracting Agency review and comment. Unless 9 otherwise stated in the Contract, the Engineer will require up to 20 calendar I 10 days from the date the Working Drawing is received until it is returned to the 11 Contractor. The Contractor shall not proceed with the Work represented by the 12 Working Drawing until comments from the Engineer have been addressed. 13 14 3. Type 2E — Same as a Type 2 Working Drawing with Engineering as described 15 below. 16 17 4. Type 3 —Submitted for Contracting Agency review and approval. Unless 18 otherwise stated in the Contract, the Engineer will require up to 30 calendar 19 days from the date the Working Drawing is received until it is returned to the 20 Contractor. The Contractor shall obtain the Engineer's written approval before 21 proceeding with the Work represented by the Working Drawing. 22 23 5. Type 3E — Same as a Type 3 Working Drawing with Engineering as described 24 below. 25 26 All Working Drawings shall be considered Type 3 Working Drawings except as 27 specifically noted otherwise in the Contract. Unless designated otherwise by the 28 Contractor, submittals of Working Drawings will be reviewed in the order they are 29 received by the Engineer. In the event that several Working Drawings are received 30 simultaneously, the Contractor shall specify the sequence in which they are to be 31 reviewed. If the Contractor does not submit a review sequence for simultaneous 32 Working Drawing submittals, the review sequence will be at the Engineer's discretion. III 33 34 Working Drawings requiring Engineering, Type 2E and 3E, shall be prepared by (or 35 under the direction of) a Professional Engineer, licensed under Title 18 RCW, State of 36 Washington, and in accordance with WAC 196-23-020. Design calculations shall carry 37 the Professional Engineer's signature and seal, date of signature, and registration 38 number on the cover page. The cover page shall also include the Contract number, 39 Contract title and sequential index to calculation page numbers. 40 41 If more than the specified number of days is required for the Engineer's review of any 42 individual Working Drawing or resubmittal, an extension of time will be considered in 43 accordance with Section 1-08.8. 44 45 Review or approval of Working Drawings shall neither confer upon the Contracting 46 Agency nor relieve the Contractor of any responsibility for the accuracy of the drawings 47 or their conformity with the Contract. The Contractor shall bear all risk and all costs of 48 any Work delays caused by rejection or nonapproval of Working Drawings. 49 50 Unit Bid prices shall cover all costs of Working Drawings. 51 1 AMENDMENTS TO THE 2014 STANDARD SPECIFICATIONS BOOK Revised: 8/3/15