2615 W CASINO RD MARKET READY 2017-01-13

� 2012 Washington State Energy Code Compliance Forms for Commercial Buildings including R2 & R3 over 3 stories and all R1 Revised Jan 2014 Project Address Paine Field Bidg. 5 ste. I Remodel Date 9/18/2015 Lighting Alterations, Renovations & Building Additions For Building Department Use �� Less than 60% �J 60% or more � Stand alone � Addition � Notes: a. Lighting fixtures in a building addition may comply as a stand alone project, or they may be combined with the overall existing bldg lighting to demonstrate compliance. Refer to C101.4.3. b. For retrofits and building additions, provide Building Area types and gross interior areas in ihe Maximum Allowed Lighting table. If a builidng addition will comply as combined wrth ihe overall existing builidng, include all applicable existing Building Area types and gross interior areas. c. Document new fixtures and alI existing to remain fixtures in ihe Proposed Lighting table. d. If less than 60% of existing fixtures wilf be replaced, use LTG-INT-SPACE form. Maximum Allo�ved Lighting Wattage Location (plan #, Building Area' room #, or ALL) Area Description Office �office �New Office area ' Select Table C405.5.2(1) Building Area from drop down menu. Proposed Lighting Watta Location (plan #, Buiiding Area` room #) Office Office Office Irestroom Fixture Description" Fluorescentlightfixture rescent downlight Watts per ft2 Area in ftz 0.90 525 Total 525 Number of Watts/ Fixtures FiMure 4 96 26 1 ` Select Table C405.5.2(1) Building Area from drop down menu. "" Include existing to remarn lighting and exempt lighting equipment per notes below. �mpliance by Building Area Total Allowed Total Prop� Building Area Warninqs Watts Watts Office (watts/ftz x area) 473 W atts Proposed 384 26 Interior Lighting Allowance 473 � 410 � COMPLIES Total 4 7 3 410 Notes: i. Proposed Wattage for each Building Area type shall not exceed the Allowed Wattage for that Building Area type. Trading wattage between Building Area types rs not allowed under the Building Area Method compliance path. 2. Proposed fixtures musf be listed in the building area in which they occur. Include ALL proposed lighting frxtures. 3. For proposed Fixture Description, indicate fixture type, lamp type (e.g. T-8), number of lamps in the fixture, and ballast type (if included). For track lighting, list the length of the track (in feet) in addition to the fixture, lamp, and ballast information. 4. For proposed Watts/Fixture, use manufacturer's listed maxrmum input wattage of the fixture (not simply the lamp wattage) and other criteria as specified in Section C405.5.1. For line voltage track lighting, list the greater of actual luminaire wattage or length of track multiplied by 50, or as applicable, the wattage of current limiting devices or of the transformer. For low voltage track lighting list the transformer rated wattage. 5. For lighting equipment eligible for exemption per C405.5.1, note exception num6er and leave Watts/Fixture blank. 6. Document existing to remain frxtures in Proposed Lighting table in the same manner as new fixtures. ldentify as existing in fixture description. �