Laserfiche WebLink
Steve Miller <br />From: <br />Sent: <br />To: <br />Cc: <br />Subject: <br />Attachments: <br />Hello Steve, <br />• <br />Carlos Alvarez <carlos@karreman.com> <br />Friday, April Ol, 2016 3:22 PM <br />Steve Miller <br />'Tim Trieb'; 'Keith Mathews' <br />11130 SE Everett Mall Way <br />M1603-032 Com Ltr 3-25-16.pdf <br />• <br />Below are the responses from our Mechanical Engineer to your comments on the Jersey Mike's Type I hood permit. <br />Item 1. There is a note on sheet A5.0 that refers to the manufacturer's wall clearance and on sheet M2 there is a detail <br />from CaptiveAire of the 3" clearance for the Griddle Hood. See note below. <br />Item 2. See note below. <br />Item 3. We will apply for a separate permit for the hood fire suppression system. There is a note on A0.0 (General note <br />#9) that fire suppression systems are under separate permit. <br />Item 4. See note below. <br />Thank you, <br />Carlos Alvarez- CSBA, LEED AP <br />Karreman+Associates <br />T:(206) 842-1253 <br />www.karreman.com <br />From: Keith Mathews [mailto:keithCa>mathewsconsultinq.com] <br />Sent: Wednesday, March 30, 2016 10:57 AM <br />To: '- -' <br />Subject: RE: 11130 SE Everett Mall Way <br />Hi Carlos, <br />My responses: <br />Item 1: The Captiveaire hood has a built in 3" standoff void between the hood and the mounting wall. The hood <br />is mounted to a noncombustible wall. <br />Item 2: The Type I hood is not a canopy type hood. It is a backshelf type and the 6" overhand is not applicable to <br />type of hood. <br />Item 4: A grease duct leak test is a code requirement and will be done at the time of the hood installation. <br />Keith <br />1�2 <br />