1402 SE EVERETT MALL WAY RUE 21 2017-01-13

• • • � e f - ' - � � 2012 Washington S1ate Energy Code Compliance Forms forCommercial Buildfngs Including R2 & R3 over 3 stones and all R1 Revised Jan 2014 Project Address rue 21 -Everett Mail Date 4/1/2016 The following information is necessary to check a permit application for compliance with ihe lighting, motor, and transformer requirements in the Washington State Energy Code, Commercial Pravisions. Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes L1GH71NG CONTROLS (Section C405.2) ' r Indicate on plans the manual cantrol type 8� focations served; Yes C40�.2.1.1 Manual interior _ C4052.1.2 lighting controls Indicate of plans the 50% lighting load reduction method provided or identify exception taken Indicaie lighting system automatic shut-off capability- identify lighting zone areas served on plans; Automatic time Yes C405.2.2.1 switch controls and �ndicate locations ot override switches on plans and the areas override switching served, include area sq. ft.; _ Indicate locations where autom atic shutoff is provided by other methods (occupancy sensor, daylight controls, etc) Yes C405,2.2.2 Occupancy sensors Indicate on plans the locations served by occupancy sensors Daylighl zones - Indicate vertical fenestration primary and secondary daylight xA C405.2,2.3 Vertical fenestratlon zone areas on plans, include sq. ft.; and skylights Indicate skylight daylight zone areas on plans, include sq. ft. Daylight zone �ndicate on plans the Iocatiorts served by daylight zone controls; xn C405.2.2.3.2 controls Indicate in plans the lighting Ioad reduction (dimming) method - stepped or continuous dimming Specific application Indicate on lans the locations served b s ecific a Ilcation Yes C4Q5.2.3 lighting controls - lighting contols y p �p General Indicate lighting controi method for display and accent lighting, and display case lighting; Yes C405.2.3 - Display and accent Items 1&2 lighting Indicate these fixtures are controlled independentlyfrom both generet area li9hting and other I ighting applications within the same space C405.2.3 - Hotellmotel guest P�Ovide a Ifghting control device ai each guest room entryfor all x7' permanently installed fixtures in guest room; Item 3 rooms fndicated whether lighting control is manual or automatic xA C405.2.3 - Supplemental task Provide automatic shut-off vacancy controls for supptemental Item 4 lighting task lighting, including under-shelf or under-cabinei lighting Identify eligiblo non-visual applications and method of ligMing control; � C405.2.3 - Lighting iar non- ----- Item 5 visual applications Indicate these fixtures are controlled independentl y from both general area lighting and other I ighting appl ications within Ute same space Indicate lighting control method for lighting equipment for sale C405.2.3- Lightingequipment ordemonsVation; NA Item 6 for sale or Indicate these fixtures are controlied independentl y Trom bath � demonstration general area lighting and other lighting applicaUons withln ihe same space If egress Ilghting power density Is greater than O.DSW /ftZ, C405.2.3 - Means of egress indicate method pf autom atic shut-ofl during unoccupied xA periods; ltem 7 lighting Identify on plans the egress fixtures that functian as both normaf and emergency means of egress illumination C405.10 Cooler and freezer Provide vacancy device or frmer to tum off fixtures within 15 NA minutes of unoccupancy for cooler and ireezer lighting fxtures C405.11 lighting with lamp effcacy less than 40 lumens per watt NA C405.2A Extenor lighting fndicate on exterior lighting plans the automatic IighUng control controls method and locations served E�erior building Provide motion sensor controls for building grounds fixtures NA C405.6.1 grounds lighting rated at greater than 100 w atts with lamp efficacy less ihan 60 controls lumens, or identify exceplion taken Identi(y applicable commissioning documentation requirements per Section C408 or eligibility for exception; Yes C408.3 Lighting system Provide wnrien procedures for functional testing of all automatic functional testing controls and descnbe lhe expected system response; Identify in construction documents the party responsible for functional tosiing of automatic lighting controis WTERIOR LIGHTING POWER & EFFICACY Sections C405.5, C405.10, C405.11}