Laserfiche WebLink
• <br />PUBL/C L�l/OR/�5 <br />Issued July 1, 2015 and revised on July 10, 20�_5 <br />Mr. Dale Parnell <br />Design Lines, Inc. <br />1915 Madison St. <br />Everett, WA 98203 <br />Project: Add Assembly Occupancy <br />Job Address: 1032 W Marine View Dr. Building C <br />Plan Review No: BW1506-006 <br />RE: Corrections Letter <br />; �ent vir� e-mail <br />a�.?/��/!_'�._ �.__ __ � <br />Dear Mr. Parnell, <br />The plans submitted have been examined and corrections are required. The owner submitted prior <br />overall plans of the building; however, the scope of work does not indicate the assembly occupancy <br />requested for this tenant space. Please submit two sets of drawings with a response letter indicating <br />how corrections are resolved on the plan set. <br />, .n `} �� f:; �� � � . r r� � � <br />General <br />b�- �` �� r'R�� �� , � i � � a °�.� �� ; � �e �. <br />� 1. Please update the plans to indicate the rrew assembly o�cupancy. Drawings should show <br />d�` current occupancy and scope of work for this permit application only. A certificate of occupancy <br />will be issued for this space. <br />2. Please indicate new work (or work that was not previously permitted, inspected, or approved) <br />�, ' for this tenant improvement only. This includes ceilings, wall sections, doors, accessible <br />parking, or any other revision where a building permit is required, per IBC section 105.1. <br />a. Existing work is typically indicated as light lines. <br />b. New work is typically indicated as dark lines. <br />c. Demolition work is typically indicated with dashed lines. <br />3. New walls should be targeted on the plans to detailed wall sections indicating the intersection of <br />the wall to the ceiling, or to the underside of structure above. <br />e f <br />4. Au��o �atic fire s�appression and fire detection and alarms should be noted on the drawings as a <br />def�re,d permit. <br />Occupancy <br />.1. The code analysis for this tenant space should be shown on the drawings to include: <br />�� a. Occupancy type, area, and occupant loads. <br />b. Applicable codes. <br />Eg ress <br />� 1. Two exits are required for the assembly use, per IBC table 1021.2(2), even if the occupant load <br />is less than 49. <br />�2 <br />