Laserfiche WebLink
2012 Washington State Energy Code Compliance Forms for Commercial, Group R1, and>3 story R2 and R3 <br /> • • <br /> � 2012 Washington State Energy Code Compliance Forms for Commercial Buildings including R2&R3 over 3 stories and all R1 Revised May 2015 <br /> �Air system exceeding 5hp �No air system exceeds 5hp G <br /> Fan Power Provide a MECH-FANSYS form for each HVAC system having a total fan system motor nameplate horsepower <br /> exceeding 5 horsepower.Refer to Section C403.2.10 and MECH-FANSYS-DOC for requirements and exceptions. <br /> • Commissioning Exception Q Commissioning will be provided for all applicable systems <br /> Summary Commissioning Exceptions: <br /> Describe means of eligibilty for Q Mechanical system(s) AHU-1 AND AHU-2 <br /> commissioning exception(capacity, <br /> etc)for all systems noted as taking <br /> exception in Mechanical Systems <br /> Summary table. Refer to Section �Service water heating <br /> C408.2 and C408.4 for exceptions. system(s) <br /> For systems requiring commissioning, Figure C408.1.2.1 Commissioning Compliance Checklist shall be submitted to the <br /> code official upon project completion. <br /> Low Energy and Semi-Heated Spaces (Note 6 and 7) <br /> Peak Space <br /> Heating Cooling Conditioning <br /> Space Area Served, Capacity, Btu/h Capacity, Btu/h Capacity, Compliance <br /> Type Location in Plan(s) Space(s)Served square feet (Note 4) (Note 5) Btu/h-sf Check Notes <br /> Note 4-Provide total installed heating output capacity of systems serving Low Energy or Semi-Heated space(s)in btuh. <br /> Note 5-Provide total installed cooling capacity of system serving Low Energy space(s)in Btu/h. Not allowed for semi-heated spaces.Enter 0 if no cooling. <br /> Note 6-Refer to Section C101.5.2 Low Energy Building.Intalled peak space conditioning capacity,heating or cooling,may nof exceed 3.4 Btu/h-sf. <br /> Note 7-Refer to Section C402 1.4 and Semi-Heated Space definition in Chapter 2. Total heating output capacity may not exceed 8 btuh/sf. Only systems without <br /> electric resistance heating and no cooling are eligible for the wall insulation exception under semi-heated. <br />