3128 BROADWAY WHOLE SITE DOCUMENTS 2016-01-01 MF Import

� � a. The grading �mprovemen[s and final (loor elevations planned for the bwiding shown relative to the site elevations. b. The location of the exterior entry steps should be dimensioned from the property line. �This drawing can be submitted either as part of the public works permit application or separateiy in ihe building permit drawing set. �4. The north arrow on the site plan submitted as an 8 'h by 14 inch drawing is pointing wesL Please indude north arrows oriented the correct direction on all plans submitted for permit. Construction P�bL� � The stairs from [he Broadway sidewalk shown on the 8 Yz by 14 inch site plan drawing �� are drawn differently than is shown on the building permit drawing east elevation or sheet �1 to access Unit A and Unit Ei. Please revise the si[e plans and floor plans :o be consistent to show lhe dimensioned width and location of the porch steps relative to units A and B. ✓ a. Please inciude the porch and stair treads for the exterior access to units A and B on the floor plans. The maximum riser height should be shown as 7 3/4". The minimum tread depth is 10 inches. R311.7. i. Show handreil on both sides 34" min, 38" max above tread nosing, 1 '/�"- 2" diameter, return ends. V ii. Guards should be detailed on the drawings where the elevation to grade exceeds 30" at the stair or porch access to [he units. R312.1 ,/b. The stair section should indude the elevation of the main, second floot. Unil A should have an additional stair section shown on the drawings for [he si�gle run stair to the third floor. R311.7. i. Show handrail on drawings to be 34" min, 38" max above tread nosing, 1 Va"-2"diameter, return ends. ii. Guards should be detailed on Uie dratvings where the elevation change exceeds 30" cn the open side of the stair run to thc third floor on Unit A. R312.1 iii. The wall consVuction at thc stairs in Unit B should bc shown at thc plan level. The run going up should be shown on the plans. iv. The winder treads shown in Unit A should be dimensioned to have a �, minimum tmad depth of 6 inches, and a minimum tread depth of 10" in � the walkline. a � �-°� . r � v. R-30 insulation required under stairs. Specify stringer size and quantity. � Show stringer attachment to main (loor joists. V" � 2. Wall sec[ions shown on sheet S and cantilever sections on sheet 6 should be targeted on [he plans. Additional sections are required on the dra�vings to show the all buiiding � a�y . �