909 N BROADWAY 2018-01-01 MF Import

3. New ceilings should be shown on the dravaings to comply with thc seismic installation details of NW Cei!ing Institute, attached. .s�. Please coordinate the review of the access to the roof hatch with AFM ]im Venturo. Accessibility ✓ 1. Please submit a written summary of compliance to provide an accessible route for alterations by a minimum of 20% of the costs of the alteration affecting the area of primary function, per IBC sections 3411.7 and 3411.8. ,/ 2. Please identify the existing or new accessible entrance on the drawings, per IBC section 3411.6. a. Please include details, referenced on the plans, for the pedestriar accessible building entrences served, per IBC sedion 3411.8.1. b. To meet the requirements of a primary accessible entrance, details on the following, where applicable: ramps, handrails, pull dimensions on the doors, and thresholds. access to the please indude and push side f 2. Within the property line, ramp, sidewalk, and stair widths should be dimensioned on the drawings to be a minimum of 44 inches, per IBC section 1101.Z.2, wher they are part of the accessible route, per IBC sedion 1104.2. � 3, New accessible parking spaces should be dimensioned on the drawings per the requirements of IBC Chapter il, to include the required van space, per IBC section 1106.5. a. Access aisles should be dimensioned per ICC/ANSI Ai17.1-2009 section 502.4. b. Parking signage should be shown on the drawings to meet the requirements of ICC/ANSI A1i7.1-2009 section 502.7. J 4. Toilet room partitions and fixture locations should be dimensioned in plan and elevation for minimum clearances or maximum distances, per ICC/ANSI A117.1-2009 Chapter 6. �. The student break area sink should bc shown in clevation to meet ICC/ANSI A117.1- 2009 section 606. ✓ 6. A vertical grab bar and toilet paper dispenser should be shown and dimensioned on che drawings at the new toilet rooms, per ICC/ANSI A117.1-2009 scctions 6045.1 and 604.7. Ene�r9� �I,�� (1./Building envelope requirements for compiiance with the energy code should be shown in ,�'1�r.. > v the code analysis and on the drewings, per the prescriptive rnethod shown on WSEC �`,� �Q�\ table 13-1, or the component method, per WSEC C101.4. � �d� Deferred Permits S� 1. Tenant improvement (for the mezzanine), mechanical, plumbing, electrical, sign, and suppression permits should be listed on the cover sheet as deferred permit applications. Tenant improvement, mechanical, sign, and suppression permits will require drawings.