930 N BROADWAY 2018-01-01 MF Import

have the required siynage for the van parking spot, a refererc : to this sheeC from the Grading plan C401 was not found. 4. Van accessible, accessible �arking and access aisles should be dimensioned on the drawincs, per ICC/ANSI A117.1-?003 section 502.7. 5. The accessible route from accessible parking areas to che accessible building entrance served should be shown on the drawings, per ICC section 1104.1, to include a curb cut, ramp, landings, handrail details, door swing clearances, etc. Although there is a Type A curb cut shown as detail 7 on civil drawing sheet C703, it is not referenced on any site drawings for its location relative to the access aisle for the accessible parking spaces. There does not appear to be enough clearance (10 feet minimum) to locate this curb ramp detail in those locations. 6. Please clarifV the clinic drop-off area from North Broadway. a. Is there designated parking marking for the dental van marking noted on sheet L100? b. Is there a passenger loading zone? If yes, then the street-Ic��•i passenger loading zone should be indicated on the architectural site plan as accessible, per IBC section 1106.7. . Access aisle: the 60 inch access aisle should be shown on the site plan, per ICC/ANSI A117.1-2003 section 503.3.1-4. • Slope: The drawings should indicate a floor surface of tfie access aisle and vehicle pull-up space should have a slope not exceeding 1:48. 7, Curb ramps should be shown and detailed on the drawings, per IBC section ].104.1 and ICC/A�SI A117.1-2003 section 406. The location, slope and design of the curb ramps is not clearly shown on sheet L100. 8. Dimensions and clearances should be shown on the drawings for doors in series (entry vestibules 131, 132) to indicate the minimiim 60 inch turning space required between doors, per I�C/ANSI Ai17.1-2003 section 404.2.5. 9. Exterior ramps on the accessibie route should indicate the foilowing specific information on the drawings: a. Dimensioned length of ramp run on the drawings (1:12 maximum rise), per ICC/ANSI A117.1-2003 section 405.2. b. Dimensioned rise for each run (maximum rise for any run is 30 inches), per IBC section 1101.2.1. c. Dimensioned width of ramp on the drawings (44 inches), per IBC section 1?.01.2.2. d. Guard detaiis (height, design and attachment) where ramp exceeds 30 inches above adjacent grade, per IBC section 1�13.1.