Laserfiche WebLink
. . � � <br /> 6. If the basement has the capacity to be heated it is required to be insulated. <br /> Show framed walls inside of existing concrete walls. Provide section at <br /> interior helow grade wall (if applicable). <br /> Framed walls shown on sheet A1.0. See wall type D3 in detail #5 on sheet <br /> A8.0. <br /> 7. Define thermal envelope. If basement is unheated, the main level floor shall <br /> be insulated to R-30. The walls around the stairs shall be insulated and an <br /> exterior door shall separate the stairs from the main floor. <br /> NIA. The basement will be heated. <br /> 8. Show all hold down locations on floor plans. Show posts or multiple studs as <br /> needed for hold down installation. <br /> All hold down locations are sliown on framing plans (sheets AF1.1, AF1.2, <br /> AF1.3�. Refer to structural sheet S-2.0 for hold down details. <br /> 9. Show all strap locations on floor plans. Specify length of straps required to <br /> achieve design loads. <br /> All strap locations are shown on framing plans (sheets AF1.1, AF1.2, <br /> AF1.3). Refer to structural sheet S-2.0 for strap details. <br /> 10.Specify header size, species and grade at living room and dining room doors <br /> supporting new deck and bathroom addition. <br /> Headers are called out on framing plans (sheets AF1.1, AF1.2, AF1.3). <br /> 11.Specify posUbeam connection and beam/beam connection at 4x10 D.F. #1 <br /> above refrigerator and 5-1/4"x9" PSL above counter at range and ovens. <br /> See sheet AF1.2 <br /> 12.Specify post size at point loads supporting 2nd floor and point loads supporting <br /> 15� floor. <br /> See sheets AF1.1 and AF1.2 <br /> 13.Specify connection of 5-1/4"x9" PSI_ and 7"x9-1/4" PSL at point between the <br /> dining room and the stairs. <br /> See sheet AF1.2 <br /> �b <br />