1205 CRAFTSMAN WAY SCUTTLEBUTT BREWING 2016-01-01 MF Import

( + 6. The inside lower edges of the Type I and II commercial hoods should be dimen�ioned on the drawings to extend minimum 6 inches beyond the edge of the top horizontal surface of .he appliance on all open sides, unless the hood is closed to the appliance side by a noncombustible wall or panel meeting the requirements of the exception to IMC section 507.9, specifically on the hood returns adjacent to wall construction: a. The extent of the smooth, cleanable, nonabsorbent and noncombustible material should be shown on the drawings and noted to extend 18 inches in all directions from the hood to the full height of the hood canopy, per the exception to IMC section 507.9. 7. Please clarify if the centrifugal blower (submitted as a cut sheet only) is the termina� exhaust fan. The exhaust fan(s) should be shown on the drawings to have an approved drain outlet at the lowest point of the housing to permit drainage of grease to an approved grease reservoir, per IMC section 506.5.2. This detail should be referenced on the sections on sheets M5 and M6. a. Please clarify on the drawings in a detail lhe exhaust fan(s) hinges and flexible weatherproof eiectrical cable (or other method of access) to permit inspection and cleaning, per IMC 506.5.3. This detail should be referenced on the sections on sheets M5 and M6. b. Please clarify if the vertical shaR with a bird-screen at the upper roof provides adequate weather protection for the inline grease duct fan on the lower roof, per manufacturer's instructions. 8. Where cleanout openings are located in ducts within a fire-resistance rated enclosure, one-hour fire-resistant access openings and signage ("ACCESS PANEL. DO NOT OBSTRUCT.") should be shown on the drawings, per IMC sections 506.3.8 and 506.3.11, in all of the required locations, to include: c. Grease duct horizontal cleanouts should be show�n on the drawings spaced not more than 20 feet apart, per IMC section 506.3.9.1. d. Where the grease ducts pass vertically through floors, cleanouts should be shown on the drawings per IMC section 506.3.9.2. e. A cleanout should be shown on the drawings for both the inlet side and outlet side of an in-line fan within 3 feet of the fan duct connection, per IMC section 506.3.8.2. 9. The following should be noted on the drawings: a. Duct materials and thicknesses, per IMC section 506.3.1. b. Grease duct leakage test coordinated with the schedule of the city inspector on-site such that the installation can be reviewed with the light test prior to , us� or concealment, per IMC 506.3.2.5. c. Greasc duct support materials and attachments, per If1C section 506.3.3.