Laserfiche WebLink
COMPLIANCE <br />REQUIRED V <br />e <br />0 <br />INSPECTIO <br />AP PROEDN I IMPORTANT: QQ NOT place checks In the two left columns. <br />Page 6 of 6 <br />f,2 Exposed foam Insulation shall comply as follows (S. 502.1.4.7): <br />❑ Protected with metal or plastic flashing, or other suitable material that extends below grade. <br />Insulation <br />EDAirflo❑w between f esh airr ports andthewhole-house fan ensured by undercuade, exterior use and properly t doors/grills (VIAQ,S. 302.6.4) <br />®Looseflll insulation OK if (S.502.1.4.5): <br />❑ maximum ceiling slope not > 3 in 12 <br />b>- 30" of clear distance from top of bottom chord to <br />black polyethylene ground cover, shall be lapped 12n at joints and extendtofoundation wallga ®6 mil <br />s Clearances shall meet listed minimums between insulation and (S.502.1.4.3): <br />❑ chimney ❑Non -IC rated recessed lights: 1/2" to combustables, 3" to insulation. <br />7 Attic hatch shall be insulated to required ceiling R-value and is weatherstripped (S.502.1.4.4) <br />Attic access shall have wood dam or equivalent to retain loose fill insulation in attic(S. 502.1.4.4) <br />d9 All exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). <br />so Service hot & cold water piping in unconditioned spaces shall be insulated to R-3(S. 503.11) <br />sr Service recirculation hot water piping in unconditioned spaces shall be insulated to Table 5-12 levels. <br />sz Heat pump thermostat shall have progamable capability (S. 503.8.3.5) <br />72 her mostat provided for each HVAC system with range of 55-75' F.(heating) (S.503.8.1.1). <br />!4J Readily accessible, automatic or Manual means provided to restrict or shut-off Heating input to each <br />zone or floor during periods not requiring heat (S. 503.8.3.1). <br />rs ontrols for backup heat prohibit similtaneous operation of the primary system (S. 503.2.2(3)). <br />;6_jMechanIcal ventilation system shall have proper timers, and/or switches (VIAQ, S. 302.3). <br />Dvechanlcal ventilation ducts shall have R-4 insulation in uncp <br />adie echanical ventilation supply ducts in conditioned spaces shall havvee RR-4 insulation (VIAQ, 302.5) <br />a uppiy ducts shall have volume dampers, or the equivalent, to balance system (S. 503.6). <br />o uppiy and return atr ducts shall have sealed duct joints in unconditioned spaces (S. 503.10.2). <br />I VAC and <br />supply, and return air ducts shall have R-8 insulation (Table 5-11, All options) <br />2 lectrlc water heater(s) shall have (S. 504.2.1, 504.3, 504.4) : <br />❑ separate power shut -oft ❑ 1987 NAECA Lable on tank <br />❑ noncompressible R10 pad (unheated spaces only) ❑ Temperature setting s 120 F. <br />showers and lavatories shall limit flow to s 3.0 gallons/minute (S. 504.8.1). <br />o3Swimming poois(S. 504.5) shall have: <br />❑ readily accessible ON/OFF switch (pump, heater) ❑Pool cover ❑Piping insulated to S. 503.11 <br />,DAII fireplaces (VIAQ, S. 402.3) shall have: <br />❑ 6 square inch combustion air supplyduct w/ accessible damper directly connected to the fire box <br />❑ Tight filling glass or metal doors. ❑ Tight fitting flue damper <br />Solid fuel burning appliance(s) (VIAQ, S. 402.2) shall have: <br />[]Tight fitting glass or metal doors <br />❑Outside combustion air source directly connected to the fire box <br />❑ Exception: Non -direct, 4" diameter, dampered, combustion air source: allowed only for (1) new stove <br />installations in existing homes where obstructionsprecludes direct combustion air, or (2) Central <br />heating systems located in unheated spaces. <br />Three month, etched track radon monitor, printed instructions, and information sheets shall be supplied <br />to the single family dwelling or first floor units of multi -family dwellings by the general contractor (VIAO,S. <br />502.2.1), <br />WSEC Final phase requirements: <br />Inspected by: <br />