607 SE EVERETT MALL WAY AA CHINA BUFFET 2016-01-01 MF Import

6. Since the occupant load is over 50 in each dining area, exit signs should identify the two means of egress from the both dining areas per IBC ]011.1. Exterior exit doors should have exterior illumination (per sectioa 1006.3-5) and tactile exit signs, per IBC 10113. 8. All new emergency egress lighting should be shown on the reflected ceiling plan, per IBC 1006.3. 9. Men's Room accessible stall door to swing out to provide minimum clear dimensions per ANSI Al 17.1 Figure G04.8.2. 10. Accessible urinals require a 30 inch wide by 48 inch deep space for wheelchair acces�. The revisions sl�own are less accessible than the previously permitted plans, per ANSI A117.1 Section 305.3. 11. The buffet equipment and layout should be accessible. The buffet counter height should be 34 inches high with a maximum reach depth of 24 inches, per ANSI A117.1 Section 308.3.2. A five foot turning radius should Ue provided around the ends of the buffet counters, where restricted by equipment or walls, per ANSI Al 17.1 Section 304.3.1. 12. Justification should be provided for the removing the lavatory in the Men's Toilet per IBC 2QQ2.1. 13. On the previously permitted plans, the employee toilet room was used by an adjacent building tenant. In the current application for permit, the freezer has blocked access to this toilet room by the adjacent building tenant. The building o�vner should verify the purpose of this door, and if the removal of the door will impact the other building tenant either for the purpose of egress or access to toilet fixtures, and that the connection behveen tenar.ts is no longer required. 14. A ne�v Type I Hood is shown where a table was indicated in the kitchen on the previously permitted plans for the casino. This tenant improvement will require a new Type I Hood permit suUmittal. The additional grcase producing equipment tmder the existing hood will require a revised suppression submittal for the existing Type I hood, per IMC 509.1. Verification of the Type I exhaust and make-up air design requirements should be submitted per IMC Section 509. Upon submission of the revised drawings, your application will be given priority and plan review will begin. All required submittlls must be of sufficient detail and information to ensure that the proposed structure will be constructed in compliance with all adopted cades. Please call me with any questions at 425-257-8813. Meg M. Plans E: CC: �th Avenue South WA 98108 Mr. Tony Lee, Perniit Services Manage�, City of Everett S:U141alcy\WorJU30604-047 607 SG Cverctt Mall Way .doc