5809 HIGHWAY PL 2016-01-01 MF Import

C 4• 17�e maximum stair riser height should be shown as 7'k". Scction 100333.3 Accessibility 1. Of the 20 units for the project, 18 have twasleeping rooms, and 2 have one- sleeping room. To meet the proportional distribudon requirements of Secdon 1103.1.8.4, the Type A unit should be a two-sleeping room arrangement. 2. All units on the ground floor that are not Type A units should comply as Type B units. Section 1103.1.8.2 3. A minimum of 12" clear should be provided between the entry door and the exterio* wall for a`push side' forward approach at thc Type A and B units as the doors have both closers and latches. Sections 1106.103, Item 2 8c 1106.27.1, Item 4 4. A minimum of 18" clear should be provided between the entry doors and wall for a`pull side' forward approach for Units F& C(basement level). Sections 1106.10.3, Item 1 8c 1106.27.1, Item 4 5. A 30" x 48" clear floor space should be provided at one cub in each Type B unit. The 48" dimension should be alongside the tub. Iavatories may encroach on the clear floor space if they are fully accessible, however toilets may not. See Units A, A.1, F and D.1. Sections 1106.27.1, Item 12, 1106.11.9.1 6. For one bathroom in each Type B unit, the edge of the lavatory should be located not less than 15 inches from the centerline of the watercloset providing the knee and tce clearances of Section 1106.11.7 are met. Otherwise the lavatory should not be locate within the clear floor space required for the toilet. Section 1106.11.5.1, Exception 1 7. The tub seat for the Type A bathroom sh�uld be shown on the plans. Section 1106.11.9.2 8. Permanent barriers should be shown around the bottom of the open stairways to prevent entry by persons with visual impairments into the areas of reduced headroom. Section 1106.4.2