5809 HIGHWAY PL 2016-01-01 MF Import

Based on the elevations and plans, 409b more `berm' is required for each building in order to avoid the three-story designation. Resubmivals should i�lude calculations, which substantiate basement classification. It s6ould also be noted that the perimeter of the overhang (first floor over the parking) of Building A should be used when determining required berm coveiage. Section 220 3. In order to avoid opening protection and exterior wall fire-resistance, the covered cazports should be separated from each building by a minimum of 8 feet. Secdons 207 & 505.3 4. The minimum one-hour occupancy separation between the Buildi,ig A dwelling units and the basement garage should be noted on the pians. 1'hc listed floor/ceiling assembly used over the basement garage should be clarified. Secdon 302.2 - Construction 1. The one-hour floor-ceiling assemblies using TJI's should use NER-200 for the tisting source (GA File FC5107 is for nomina12x10's). Based on Assembly E-7, if the ceiling from Assembly E-6 were used (RC-1 channels (� 16" o.c.), USG Thermafiber or Fibrex FBX mineral wool bats would be required as well as 5/8" USG Type C Firecode gypsum wallboard. 2. Window type C adjacent to a bathtub should be shown as safery glazing. Section 2406.4 3. The shaft construction at the fireplaces should be continuous through the floor/ceiling and roof/ceiling assemblies. Section 711.2 4. Connection, construction and fire-resistive details of the onc-hour bolt-on deckleu should be provided. Section 606.1 Exiting 1. The unit entry doors within rated stair enclosures should be shown as having a maximum temperature rise of 450 degrees. Section 1005.3.3.5 2. The envelope of the one-hour stair enclosure (eastern stair) should be maintained to the exterior (edge of roof or story above) of Building A. Section 1005.3.3.3 3. A1l openings below and within ten feet of unprotected openings in the stair enclosures should be shown protected with 45 minute rated assemblies - except for emzrgency egress windows which should be located a minimum of 10 feet away. Section 10033.3.10 2��