2531 GRAND AVE 2016-01-01 MF Import

2. The new stair at the end of the existing service �valk does not meet the minimum current requirements for an exit with a minimum width of 36 inches, per IBC section 1009.1, exception 1, and should be shown as removed on the drawings submitted for permit. a. Any increase in the width of the current service walkway would have to be reviewed and approved by the Planning Department, due to current setback requirements. b. Historical county assessor records indicate the'service waik' on the back of the building. The'walk' on the front of the building, as shown on those records, provided the only egress for the units on the second Floor, as of August 31, 1967. Construction 1. The new sliding glass door from the bedroom should indicate a landing on both sides of the door, at the minimum width for the operable portion of the door opening, per IBC section 1008.1.5. a. The new service walkway depth, reyuired to provide a landing, shou!d be shown at the same depth as the existing service walkway, on the drawings. 2. A ouard should be shown on the drawings at the new and existing service walkway for the portion of the service walkway that can be acces�ed from the sliding glass door from unit 6, per IBC seclion 1013. Elevation and section details for the openings of the guard and the height of the guard should be sh�wn on the drawings. 3. Smoke alarms for the unit should be shown on the drawings, per IPMC section 7�4.2. q. The malerial for the vertical giazing and skylights should be shown on the drawings, per IBC sections 2405 and 2406. The degree of the roof pitch should be shown on the drawings, per IBC section 2405.1. 5. The portion of the interior wall near the kitchen that was removed should be shown on the drawings as demolished, and the new counter wall should be shown as new on the drawings submitted for permit. Energy 1. A reFlected ceiling plan indicating how the ceiling cavity was modified to instali the skylights, including the location of the insulation to fill the exposed cavity, should be s{iown on the drawings, per WSEC section 101.3.2.5. 2. Manufacturers catalog cuts should be submitted for the new glazing (vertical fenesU�ation and skylights) to show compliance with WSEC Table 13-1.