18 W MCGILL AVE 2018-01-02 MF Import

COMPLIANCE REQUIRED V INSPECTION APPROVED IMPORTANT: Please supply Information In the shaded boxes and check the appropriate circles. Disregard topics that don't describe your building or equipment. DO NOT place checks in the two left columns. D ❑ © Exterior slab Insulation, it not located on the interior, shall be R-10 (Table 6-2). ❑ ❑ Q Exterior slab Insulation, if present, shall approved for below grade use and protected above grade. ❑ ❑ QWalls, including rim joists, shall be insulated without compression to (Table 6-2): OR-15 batt (Options 1.11) *R-19 (Option 111, IV, V,'VI, VII) ❑ ❑ ®Interior below grade walls shall be insulated without compression to (Table 6.2) R-15 (Options I, 11) i` 0 DR-19 (Options 111, IV, V, VI, VII) _ ❑ ❑ QVaulted ceilings shall be insulated without compression to R-30 (Table 6.2, All options) ' UM MIN 10110 Skylight wall insulation is installed and equivalent to the required wall R-values above. Vapor retarders shall be installed toward the warm surface as represented below (502.1.6) Select one option for floors, walls, and appropriate ceilings: Floors: PlywoodW/ exterior glue 0 Poly (> 4 Mil) ,0 Backed batts Walls: Poly plastic (2 4 Mil) 0 Face -stapled, backed batts ® PVA paint ' Ceilings: Not required where ventilation space `averages >12" above insulation. Face stapled backed batts 0 Poly plastic (r_ 4 mit) is PVA paint QHeating system efficiency and sizing requirements shall be met as re res ® Heat Pump efficiency shall be mot underthe following compliance patp 0 Split system, air source I seat pump: HSPF'2 6.8 COP > 3.0 0 Single package, air source heat pump: HSPF a 6.6, COP > 3.0 0 Water source heat pump: COP 2 3.8 0 Ground source heat pump COP a 3.0 QQ Central force -air furnace AFUE rating, as listed in the LAMA Directory, shall be: �2 .78 (Options I, 11,1V, VI, VII) 0 z;.88 (Option III)) 0>-24 (Option V) §6! Non -central, combustion heating systems shall have intermhent ignitionMaximum heating system output (150%of design heat load) is _ BTU1hr. (S. 503High efficiency forced -air furnace (s 55,000 BTU/hr. output)may may exceed 150%of DHL because: OGAMA listed AFUE IF > 78 + t per each 5000 BTUlhr output that it exoeedsthe t] , pectea sulation phase re,ulrements: — Inspected by: Date ❑ ❑ ©s Envelope Floors shall be insulated without compression, and with support s 2w O.C. to: OR19 (Options 1,11, III, IV, V) 0 R25 (Options VI, Vin ❑ ❑ e° Non -vaulted, attic ceilings shall be Insulated without compression to; 4DR-30 (Options 1, 1i, III, IV, V, Vin 0 R38 (Op!lon VI) See Table 6-2 ❑ ❑ Q Door systems shall meet: U.40 (All options) Door types are(1)gYralATr'>>r (2)_ (3) Page 5 of 6