18 W MCGILL AVE 2018-01-02 MF Import

COMPLIANCE REQUIRED Gr INSPE 1ON I IMPORTANT: DO NOT place checks In the two left columns. APF � I O O Exposed foam insulation shall comply as follows (S. 502.1.4.7): ❑ Protected with metal or plastic flashing, or other suitable material that extends below grade. ❑ Insulation is approved for sub -grade, exterior use and properly installed. O 0 E3)Alrflow between fresh air ports and the whole -house fan ensured by undercut doors/griils(VIAQ,S. 302.6.4) 0 0 ®Loosefiil Insulation OK if (S.502.1.4.5): p maximum ceiling slope not > 3 in 12 ❑a 30" of clear distance from top of bottom chord to underside of roof sheathing at the roof ridge. 0 0 e 6 mil black polyethylene ground cover, shall be lapped 12" at joints and extend to foundation wall O [:3Clearances shall meet listed minimums between insulation and (S.502.1.4.3): ❑ chimney ❑Non -IC rated recessed lights: 1/2" to combustabies, 3" to insulation. O El 'D Attic hatch shall be insulated to required ceiling R-value and is weatherstripped (S.502.1.4.4) 0 0 Attic access shall have wood dam or equivalent to retain loose fill insulation in attic(S. 502.1.4.4) O 0 All exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). O O Service hot & cold water piping in unconditioned spaces shall be insulated to R-3(S. 503.11) O ElService recirculation hot water piping in unconditioned spaces shall be insulated to Tablo 5-12 levels. O 0 Qz Heat pump thermostat shall have progamable capability (S. 503.8.3.5) O 0 �2 Thermostat provided for each HVAC system with range of 55-75' F.(heating) (S.503.8.1.1). 00 �q Readily accessible, automatic or Manual means provided to restrict or shut-off Heating input to each zone or floor during periods not requiring heat (S. 503.8.3.1). O 0 s ontrols for backup heat prohibit similtaneous operation of the primary system (S. 503.2.2(3)). 0 p 6 echanlcal ventilation system shall have proper timers, and/or switches (VIAQ, S. 302.3). 00 7 echanlcal ventilation ducts shall have R-4 insulation in unconditioned spaces (VIAQ, S. 302.5) O 0 e echanlcal ventilation supply ducts in conditioned spaces shall have R-4 insulation (VIAQ, 302.5) O 0 a 1 pply ducts shall have volume dampers, or the equivalent, to balance system (S. 503.6). O 0 upply and return alr ducts shall have sealed duct joints in unconditioned spaces (S. 503.10.2). 0 O r VAC plenums, supply, and return air ducts shall have R-8 Insulation (Table 5-11, All options) 0 0 2 Iectric water heater(s) shall have (S. 504.2.1, 504.3. 504.4) : ❑ separate power shut-off ❑ 1987 NAECA Lable on tank ❑ noncompressible R10 pad (unheated spaces on.y) 0 Temperature settings 120 F. 0 0 showers and lavatories shall limit flow to s 3.0 gallons/minute (S. 504.8.1). 0 0 oSwimming pools(S. 504.5) shall have: ❑ readily accessible ON/OFF switch (pump, heater; ❑Pool cover ❑Piping insulated to S. 503.11 0 0 QQ All fireplaces (VIAQ, S. 402.3) shall have: 0 6 square inch combustion air supplyduct w/ accessible damper directly connected to the fire box ❑ Tight fitting glass or metal doors. ❑ Tight fitting flue damper 0 O s Solid fuel burning appliance(s) (VIAQ, S. 402.2) shall have: ❑Tight fitting glass or metal doors ❑Outside combustion air source directly connected to the fire box ❑ Exception: Non -direct, 4" diameter, dampered, combustion air source: allowed only for (1) new stove installations in existing homes where obstructionspreciudes direct combustion air, or (2) Central heating systems located in unheated spaces. 0 0 F7D Three month, etched track radon monitor, printed instructions, and information sheets shall be supplied fo the single family dwelling or first floor units of multi -family dwellings by the general contractor (VIAQ,S. 502.2.1), WSEC Final phase requirements: Inspected by: Page 6 of 6