1721 MCDOUGALL AVE 2018-01-02 MF Import

COMPLIANCE REQUIRED V E3 D 0 a O CO O O O ID 0 O ID 0 0 0 JILT AP INSPECTIOPROEDN I IMPORTANT: DO NOT place checks in the two left columns. FINA SE {Contind d L5JExposed foam Insulation stall comply as follows (S. 502,1.4.7): ❑ Protected with motO or piastic flashing, or other suitable material that extends below grade. ❑ Insulation is --ipprrived for sub -grade, exterior use and properly installed. ]4lrfiow between fresh air ports and the whole -house fan ensured by undercut doors/grills(VIAQ,S. 302.6.4) 1Looseflll Insulatior OK A (S.502.1.4.5): ❑ maximum ceiling slop) not > 3 in 12 0230" of ci.,l; distance from top of bottom chord to underside of roof sheathing at the roof ridge. 936 will black polyethylene ground cover, shall be lapped 12" at joints and extend to foundation wail Clearances shall meet listed minimums between insulation and (S.502.1.4.3): ❑ chimney ❑ Non -IC rated recessed lights: 1/2" to c^mbustables, 3" to insulation. o Attic hatch shail be insulated to required ceiling R-value and is weatherstripped (S.502.1.4.4) r Attic access shall have wood dam or equivalent to retain loose fill insulation in atlic(S. 502.1.4.4) a All exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). Service hot & cold water piping in unconditioned spaces shall be insulated to R-3(S. 503.11) r Servlce recirculation hot water piping in unconditioned spar^s Sha.:i he insulated (Tab!e 5-12). eat pump thermostat shall have progamabie capability (S. bJ .5.3.51 hermostat provided for each HVAC system with range of 55-75' F.(heatinc� (S.503.8.1.1). Readily accessible, automatic or Manual means pr nvidei ;o restrict or sl..q-oft Heating input to each zone or floor during periods not requiring heat tS. 503.8.3.1). lDcontrols for backup heat prohibit similtaneous operalien c` the primary I;;,tem (S. 503.2.2(3)). echanlcal ventilation system shall have proper timers, and/oI switches (VIAQ, S. 302.3). JIMechanical ventilation exhaust ducts in unconditioned :,paces shall have R-4 ins. (VIAQ, S. 302.5) echanical ventilation supply ducts in madi_tione_d spaces shall have R-4 ins.(VIAQ, 302.5) upply ducts shall have volume dampers, or the equivalent, to b _,lance system ins. (S. 503.6). )Supply and return air ducts shall have sealed duct joints in unconditioned spaces !S. 5U3.10.2). VAC plenums, supply, and return air ducts shall have R-8 insulation (Table 5-, All options) Water heater(s) shall have (S. 504.2.1, 504.3, 504.4): ❑ separate power, or gas shut-off ❑ 1987 NAECA Label on tank ❑ Elect only: noncompressible At pad (unhealed spaces, slabs) ❑ Temperature setting s 120 F. )Showers and lavatories shall limit flow to s 3.0 gallons/minute (S. 504.8.1). )Swimming pools(S. 504.5) shall have: ❑ readily accessible ON/OFF switch (pump, heater) ❑Pool cover ❑ Piping insulated to S. 503.11 )All fireplaces (VIAQ, S. 402.3) shall have: ❑ 6 square inch combustion air supplyduct w/ accessible damper directly connected to tl,e fire box p Tight fitting glass or metal doors. ❑ Tight fitting flue damper Solid fuel burning appliance(s) (VIAQ, S. 402.2) shall have: ❑Tight fitting glass or metal doors ❑Outside combustion air source directly connected to the fire box ❑Exception: Non -direct, 4" diameter, dampered, combustion air source: allowed only for (1) new stove Installations in existing homes where obstructions preclude direct combustion air, or (2) Central heating systems located in unheated spaces. Three month, etched track radon monitor, printed instructions, ai.1 information sheets shall be supplied to the single family dwelling or first floor units of multi -family dwellings by the general contractor (VIAQ,S. 502.2.1), WSEC Final phase requirements: Inspected by:__