4729 VIEW DR 2016-01-01 MF Import

I ' Page I of 4 C.O.E. # ,SJIS� Date IZ�L�/9S f7��f� �j�«,vv � T�`,�ys C litC..�� lJ/2`p /,c6 � Cc7/'•-2�.C7,.yJ L�>?'E� RESIDENTIAL CORRECTION LIST 1995 Washington State Energy Code and Ventilation and Indoor Air Quality Code WSEC Please specify, on the drawings, the R-values of the insulation in the roof-ceilings, above grade walls, below grade walls, floors and slab on grade. � Speci� on the plans the tested U-values, and sizes of the windows, skylights and doors. 502.1.5, 1006 � Please provide heat loss calculations and U-values for components of each element justifying compliance by the Component Performance Approach. � Show insulation in all elements between the heated and unheated space. � Show at lea:.� one inch of vent space above the ceiling insulation with cross ventilation. �� 502.1.4.5 � Show the vent baEtles at the eaves and specify a rigid material, resistant to wind driven moisture extending at least six inches above noncompressed insulation and twelve inches above loose 611 insulation. 502.1.4.5 � Show slab insulation providing a thertnal break between the interior and exterior. The insulation should extend downward from the top of the slab for a total distance of 24 inches or downward to the bottom of the footing on the exterior. 502.1.4.8 The detail(s) shown do not comply. � Provide a ground cover of six mil black polyethylene or approved equal for the crawl space. Lap edges 12". 502.1.6.7 (( 9�' Specify on the plans that insulation exposed to the exterior shall be protected and listed for that �� use. 502.1.4.8 � Specify on the plans the type of vapur retarders to be installed on the wacro side of the insulation for ceiling, walls and floor. 502.1.6.1 I1 Note on the drawings that insulation shall be provided with clearances for venting, chimneys, lights, etc., in accordance with the manufacturer's specifications. 502.1.4.3