4729 VIEW DR 2016-01-01 MF Import

� Page 1 of4 � C.O.E. # SIJIIS6 � I Date 12�7/9S ' RESIDENTIAL CORRECTION LIST 1995 Washington State Energy Code and Ventilation and Indoor Air Qualiry Code � WSEC � Please specify, on the drawings, the R-values of the insulation in the roof-ceilings, above grade walls, below grade walls, floors and slab on grade. (, Z.// Specify on the plans the tested U-values, and sizes of the windows, skylights and doors. � 502.1.5, I006 Y 3�' Please provide heat loss calculations and U-values for components of each element justifying , � compliance by the Component Performance Approach. � Show insulation in all elements between the heated and unheated sp:.ce. ,/�7 Show at least one inch of vent space above the ceiling insulation with cross ventilation. Y 502.1.4.5 �( 6�1 Show the vent baf�les at the eaves and specify a rigid material, resistant to wind driven moisture v extending at least six inches above noncompressed insulation and twelve inches above loose fill insulation. 502.l.4.5 � Show slab insulation providing a tl�ermal break between the interior and exterior. The insulation should extend downward from the top of the slab for a total distance of 24 inches or downward to the bottom of the footing on the exterior. 502.1.4.8 The detail(s) shown do not comply. �8:/ Provide a ground cover of six mil black polyethylene or approved equal for the crawl space. Lap edges 12". 502.1.6.� � Specify on the plans that insulation exposed to the exterior shall be protected and listed for that use. 502.1.4.8 � Specify on the plans the type of vapor retarders to be installed on the wartn side of the insulation for ceiling, walls and floor. 502.1.6.1 i l Note on the drawings that insulation shall be provided with clearances for venting, chimneys, lights, etc., in accordance with the manufacturer's specifications. 502.1.4.3