3614 WETMORE AVE 2018-01-02 MF Import

16. Exterior (court) walls within .................... feet of lines should be of ...:............. hour construction. Section .................... 03 (a). 17. Openings in exterior (court) walls within ........... feet of property lines should be protected with three fourths hour fire assemblies. Section . . .................... 03 (b). 18, Usable space under the first floor except in Group I (J) Occupancies should be enclosed as required in Section 1703. 19. Fire -resistive construction for structural frame elements in the exterior walls should comply with Footnote No. 1 of Table No. 17-A and Section ......................... See Section 1702 for clarification. 20. 8uilding paper should be applied to exterior walls as specified in Section 1707 (a). 21. Enclosures for floor openings should comply with Table No. 17•A. Section 1706. Details should clearly indicate this. 22. Structural members carrying masonry or eon. crete walls in buildings over one story in height should be protected with minimum one -hour fire protection. Section 1708. . Nonabsorbent finish and backing, for toilet room walls and floor should conform with Section 1711 (a). 24. Shower stall walls should be finished with a hard, nonabsorhent surface to a height of 6 101 feet. Section 1711 (b). 25. Doors and panels of shower and bathtub en- closure should comply with Section 1711 (e) to (C)• 26.'iParapet walls not less than ................ inches in ieight are required. Section 1709. h27. Eave overhangs and similar architectural pro- jections should comply with Section 1710. p.......................................................................... 28. Projections beyond the exterior wall should con- form with the least restrdive of the following: (a) A point one-third the distance to the proper. ty line from an exterior wall. Section 504 (b). (b) A point one-third tf.e distance from an as- sumed vertical plane located where fire' resistive protection of openings is first re- quired due to location of property. Section 504 (b). 29. Envelope ceilings should satisfy the following conditions [Section 4301 (b) 6.1: (a) Should not be used to provide fire protec. tion beam and Girders supporting more than one floor. (b) Columns should be Individually fire pro- tected. (c) Duct and outlet openings are limited to 100 square inches in each 100 square feet of [oiling area and should be protected with approved fire dampers. (d) Electrical outlet boxes should be of steel and not greater than 16 square inches in area. 30.E Gypsum board ceilings in conjunction with fire - resistive assemblies should be supported at intervals not exceeding 16 inches. Itein 27, Table No. 43-C. 31.' wood stripping or suspended wood systems for gypsum board ceilings should be not less than 2-inch nominal thickness. Section 4704 (b). . [Section 4703 (b) for wall stripping.] 32. Final partition layouts and details should be sub- mitted prior to installation to justify compli- ance with occupancy, fire -resistive, structural, and exit requirements. 33. Justifying test data in conformance with Section 106 or an ICRO research recommendation is requiredfor ....................................................... 34. Rooms in which rubbish (linen) chutes terminate should be separated from the remainder of the building with a one -hour occupancy separation. Section 1705 (c). 35. Openings into rubbish and linen chutes should not be located in required exit corridors or stairways. Section 1706 (c). SPECIAL OCCUPANCY REQUIREMENTS Group B 36. R-3 Occupancies should be of one -hour fire. resistive construction if located in a basement or above.the first story. Section 702 (b). 37. 8.2 Occupancies with an occupant load of 1000 or more should be in Type I, II, III one hour, III Heavy Timber or IV one hour buildings. The assembly room should not be in a basement it it contains this high occupant load. Section 702 (b). 38. The main entrance should front directly upon or have'a 20-toot wide access to a public way at least 20 feet in width. Section 703. 39. Light and ventilation should comply With Section 705. 40. A One Hour Fire Resistive Occupancy Separation is required between the boiler or central heat. ing plant and the rest of the building. Section 708. 41. Lxtrrior openings for rooms containing a boiler or central heating plant should be protected with !hrce-fourths hour fire resistive assemblies that art fixed, automatic, or self -closing if lo- cated belc,v openings in another story or if less than 10 feet from other doors or windows in the same buPdi=g. Section 708. Group C 42. Atmospheric separations should comply with Section 802 (b). ' 43. Use of rooms should be clarified. Note that rooms in Divisions 1 and 2 Occupancies used for day care purposes and rooms used for kindergarten, first, or second Dade pupils and Division 3 Occupancies cannot be located above the first story. Section 802 (c). 44. Special hazard rooms should be separated from other portions of the building by not less than a One -Hour Fire -Resistive Occupancy separa• lion. Section 802 (d). 45. One required exit should front directly upon, or have n 20-foot wide access to, a public way at least 20 feet in width. Section 803 (a). 46. Sanitary facilities should be provided in accord. ance with Section 805. _ 47. 1 ighl and ventilation should comply with Section 80' Sheet No. 2 of 6 Sheets