Trinity Contractors, Inc 3/1/2017

I 1 by the Engineer. The Contracting Agency will not test the split of the 2 sample with the same equipment or by the same tester that ran the I3 original acceptance test. The sample will be tested for a complete 4 gradation analysis, asphalt binder content, and Va, and the results of 5 the retest will be used for the acceptance of the HMA mixture in place 1 6 of the original mixture sublot sample test results. The cost of testing 7 will be deducted from any monies due or that may come due the 8 Contractor under the Contract at the rate of $250 per sample. I9 10 5-04.3(9)C Mixture Acceptance— Nonstatistical Evaluation 11 5-04.3(9)C1 Mixture Nonstatistical Evaluation — Lots, Sublots, I 12 Sampling, Test Section, Testing, Retests 13 For HMA mixture accepted by Nonstatistical Evaluation, comply with 14 the requirements in Table 13: I 15 Table 13 Nonstatistical Evaluation Lots, Sublots, Sampling, Test Section, Testing, Retests IComply with the Comply with the Specifications Below Requirements of the Section for: I Lots and Sublots Section 5-04.3(9)B1 Statistical Evaluation Sampling Section 5-04.3(9)62 Statistical Evaluation I Acceptance Tests Section 5-04.3(9)B3 Statistical Evaluation Retests Section 5-04.3(9)B7 Statistical Evaluation 16 I 17 5-04.3(9)C2 Mixture Nonstatistical Evaluation -Acceptance 18 Each mixture lot of HMA produced under Nonstatistical Evaluation, 19 for which all sublot acceptance test results (required by Table 13) fall 20 within the Job Mix Formula Tolerances for Nonstatistical Evaluation in 21 Section 9-03.8(7), will be accepted at the unit Contract price with no 22 further evaluation. I 23 24 5-04.3(9)C3 Mixture Nonstatistical Evaluation — Out of Tolerance 25 Procedures I 26 Each mixture lot of HMA produced under Nonstatistical Evaluation, 27 for which any sublot acceptance test result (required by Table 13) 28 falls outside of the Job Mix Formula Tolerances for Nonstatistical 29 Evaluation in Section 9-03.8(7), shall be evaluated in accordance with I 30 Section 1-06.2 and Table 14 to determine a Job Mix Compliance 31 Price Adjustment. 32 ITable 14 Nonstatistical Evaluation — Out of Tolerance Procedures Comply with the Following' Pay Factors2 Section 5-04.3(9)B4 Composite Pay Factors3 Section 5-04.3(9)B5 Price Adjustments Section 5-04.3(9)B6 I 'When less than three mixture sublots exist, backup samples of the existing mixture sublots shall be tested to provide a minimum I I AMENDMENTS TO THE 2016 STANDARD SPECIFICATIONS BOOK Revised: 8/1/16