Trinity Contractors, Inc 3/1/2017

of three sets of results for evaluation. If enough backup samples are not available, the Contracting Agency will select core sample locations from the Roadway in accordance with WSDOT Test111 Method T 716, take cores from the roadway in accordance with WSDOT SOP 734, and test the cores in accordance with WSDOT SOP 737. 2The Nonstatistical Evaluation tolerance limits in Section 9-03.8(7) will be used in the calculation of the PF,. 3The maximum CPF shall be 1.00. 1 2 5-04.3(9)D Mixture Acceptance—Visual Evaluation 3 Visual Evaluation of HMA mixture will be by visual inspection by the 4 Engineer or, in the sole discretion of the Engineer, the Engineer may 5 sample and test the mixture. 6 7 5-04.3(9)01 Mixture Visual Evaluation — Lots, Sampling, Testing, 8 Price Adjustments 9 HMA mixture accepted by Visual Evaluation will not be broken into 10 lots unless the Engineer determines that testing is required. When 11 that occurs, the Engineer will identify the limits of the questionable 12 HMA mixture, and that questionable HMA mixture shall constitute a 13 lot. Then, the Contractor will take samples from the truck, or the 14 Engineer will take core samples from the roadway at a minimum of 15 three random locations from within the lot, selected in accordance 16 with WSDOT Test Method T 716, taken from the roadway in 17 accordance with WSDOT SOP 734, and tested in accordance with 18 WSDOT SOP 737. The Engineer will test one of the samples for all 19 constituents in Section 5-04.3(9)B3. If all constituents from that test 20 fall within the Job Mix Formula Tolerances (for Visual Evaluation) in 21 Section 9-03.8(7), the lot will be accepted at the unit Contract price 22 with no further evaluation. 23 24 When one or more constituents fall outside those tolerance limits, the 25 other samples will be tested for all constituents in Section 5- 26 04.3(9)B3, and a Job Mix Compliance Price Adjustment will be 27 calculated in accordance with Table 15. 28 Table 15 Visual Evaluation —Out of Tolerance Procedures Comply with the Following Pay Factors' Section 5-04.3(9)B4 Composite Pay Factors2 Section 5-04.3(9)B5 Price Adjustments Section 5-04.3(9)B6 'The Visual Evaluation tolerance limits in Section 9-03.8(7) will be used in the calculation of the PF;. 2The maximum CPF shall be 1.00. 29 30 5-04.3(9)E Mixture Acceptance — Notification of Acceptance Test 31 Results 32 The results of all mixture acceptance testing and the Composite Pay 33 Factor (CPF) of the lot after three sublots have been tested will be 34 available to the Contractor through The Contracting Agency's website. I AMENDMENTS TO THE 2016 STANDARD SPECIFICATIONS BOOK Revised: 8/11°5