2000 HEWITT AVE EVERETT EVENT CENTER 2016-01-01 MF Import

' �[ '<� controls, receptacles or dispensers are no higher than 40"A.F.F. - see sheet A6.0. Section 1105.2.3 BN&H: Addendum No. 2, dated May 20, 2003, clarifies these requirements by added General Notes # 9 and 10 on drawinc� sheets A6.0, A6.1 and A6.2. 2. Hot water and drainpipes exposed under the lavatories should be shown guarded or wrapped to prevent contact. Section 1106.11.7.4 BN&H: Addendum No. 2, dated May 20, 2003, clarifies these requirements by added General Note#2 on drawing sheets A6.0, A6.1 and A6.2. 3. Tlie clearances in the accessible toilet stalls should be dimensioned on the plans. Section 1106.11.5.2 BN&H: Addendum No. 2, dated May 20, 2003, clarifies these requirements by added General Notes #6 and 7 on drawing sheets A6.0, A6.1 and A6.2. Dirt�ensions shown on drawing shee�s A6.0, A6.1 and A6.2 provide for those clearance requirements. 4. The top of the seat of the accessible water closets should be shown between 1 i"-19" A.F.F. Section 1106.11.5.2 BN&H: Addendum No. 2, dated May 20, 2003, clarifies this requirement by added General Note# 3 on drawing sheets A6.0, A6.1 and A6.2. 5. The flush controls of the accessible water closets should be shown on lhe wide side of the toilet stail - See elevation 5/A6.0 (and typ.) Section 1106.11.5.4 BN&H: Addendum No. 2, dated May 20, 2003, clarifies this requirement by added General Note#4 on drawing sheets A6.0, A6.1 and A6.2. 6. When urinals are provided, at least one should comply with the following as specified in Section 1106.11.6 (Section 1105.2.2): a. The side shields may project no farther than the front edge of the urinal rim. b. The urinai should have an elongated rim, at a maximum of 17 inches above the floor. c. Flush controls must be mounted not more than 44" A.F.F. BN&H: Addendum No. 2, dated May 20, 2003, clarifies these requirements by added General Note # 1 on drawing sheets A6.0, A6.1 and A6.2. 7. The minimum 36" width of the ambulatory accessible toilet stalls should be dimensioned on the plans. The door should be specified to be seif-closing. Section 1106.11.4 BN&H: Addendum No. 2, dated May 20, 2003, ciarifies these requirements by added General Notes # 5 8 7 on drawing sheets A6.0, A6.1 and A6.2. 8. The pians should show the accessible lavatories (minimum of one per toilet room) have a knee clearance of not less than 27 inches in height, 30 inches in width and 17 inches in depth. Section 1106.11.7.3.1 BN&H: Addendum No. 2, dated May 20, 2003, clarifies these requirements by added General Note # 8 on drawing sheets A6.0, A6.1 and A6.2. Confirming dimensions are shown on those drawiny sheets. 9. Water fountains should be detailed so that compliance with Section 1106.13 may be verified. =l�P