1318 37TH ST 2018-01-02 MF Import

Plan Check Review Nos. B59674, B59674, B59676 October 13, 1998 Page 3 of 9 02. The doors entering the stair enclosure in Building I from the pedestrian walkway from Building II should be shown to be a minimum 90-minute assembly with a maximum temperature rise not to exceed 450 degrees. Sections 409.7 & 1005.3.5.3 C;31 he wall types shown on Sh:et A-5.0 should be keyed into the plans. y� The wall type for the two-hour elevator shaft should be called out. / The listing for the two-hour wall type shown around the stair enclosure in Detail 2/A-8.0 should be provided. Note that nonsymmetrical wall construction must comply with Section 709.5. I 6�Wall construction Details 5, 6 & 7/A-5.0 show 1/2 inch GWB in rated assemblies. The listings should be provided for verification. Additionally, each rated wall should have the listing shown on the plans for field construction and inspection. Table 7-13 07.The listing for the one -hour rated exterior balcony in detail 3/A5.0 should be provided. Section 1006.3.2.3 It should be noted and detailed on the plans that penetrations of fire -resistive walls should be protected for through and membrane penetration protection. Section 709.6.1 9. It should be noted and detailed on the plans that penetrations of fire -resistive horizontal assemblies shall be protected for through penetrations. Section 710.2 1 Duct penetrations into the ceiling require fire dampers (ceiling rated) per Section 713.11. The method of protection should be detailed on the plans - note that kitchen exhaust (stove) ducts are not permitted to be equipped with fire dampers per the UMC. Details J the guardrails including the height, spacing of members and structural attachments 0should be shown on the plans. Section 509 12. lass I standpipes are required. The location should be shown on the plans. Section 904.5 Fire protection is required during construction. The provisions of under Section 904.6 should be noted on the plans. _A! A draftstop is required in the attic such that the greatest horizontal dimension between draftstop and ASW (or exterior wall) is not more than 100 feet. Section 708.3.1.2.1 �. The location of the attic access opening should be shown for each attic space. Section 1505.1