1318 37TH ST 2018-01-02 MF Import

C Plan Check Review Nos. B59674, B59674, B59676 October 13, 1998 Page 4 of 9 1 Safety glazing should be shown for the glazing at the stair landings in Detail 2/A-3.0. Section / 2406.4 Safety glazing should be shown for the glazing adjacent to the sliding glass doors within the dwelling units. Section 2406.4 Safety glazing should be shown for the glazing adjacent to the tubs in the end units. Section 2406.4 The plans should show that a listed smoke detector is placed near the elevator entrance that upon f activation will prohibit the elevator from opening and shall return it to the main floor. Section 3003.2 The minimum 3 square foot elevator hoistway vent should be shown on the plans. Section 3004 Area Separation Wall As there are no horizontal area separation wall provisions, the intent of the note showing one hour fire protection at the ends of the ASW should be clarified. Section 504.6.4 0'a he area separation wall should be shown to completely divide the R-1 building into two separate reas. As the exit balconies are floor area per the definition in Section 207, the ASW should continue to the outermost edge of the buildings being separated. Section 504.6.3 C3. Openings within the ASW should be shown to be 90-minute rated, self -closing assemblies. Sections 504.6.2 & 713.6.1 4. The reference to Detail 4/5-10 on Sheet A 7.0 for the area separation wall should be revised to Detail 9/5-10. bSolid blocking to the width of the finished wall thickness should be shown where the top chord of a floor truss penetrates the area separation wall in Detail 9/S-10. Section 504.6.1 All roof plans should show the area separation wall locations, as well as the 10' wide zone where no openings are permitted. Currently there appears to be a drain and ridge vent in that location. Section 504.6.4 '.7/The elevations show gable -end roof vents where an area separation wall occurs. These vents should be relocated. Section 504.6.4