1228 58TH PL SW 2016-01-01 MF Import

COMPLIANCE • REQUIRED INSPEC-TION IMPORTANT: DDlL01 place checks In the two left columns. APPROVED p p ®z Exposed foam insulation shall comply as follows (S. 502.1.4.7): ❑ Protected with metal or plastic flashing,or other suitable material that extends below grade. ❑ installed. insulation is approved for sub-grade, exterior use and properly p ❑ �AlHlow between fresh air pons and the whole-house fan ensured by undercut doors/grills(VIAO,S.302.6.4) p p QLooseflll insulation OK d (S.502.1.4.5): ❑ maximum ceiling slope not > 3 in 12 E3;.30"of clear distance from top of bottom chord to underside of roof sheathing at the roof ridge. C3 p �6 mill black polyethylene ground cover, shall be lapped 12" at joints and extend to foundation wall CJ p s Clearances shall meet NoneC red msted recenimums ssed Ighis en 51/2 t to combus abon and ?es,3"to Insulation, ❑chimney ❑ -value and is weatherstripped (5.502.1.4.4 C:] p EDAttic hatch shall be Insulated to required ceiling R O p a Attic access shall have wood dam or equivalent to retain loose fill insulation in attic(S. 502.1.4.4) C3 p e All exterior doors (except 20 minute doors) shall be weatherstripped (S.502.4.3). ED o Service hot & cold water piping in unconditioned spaces shall be insulated to R 3(S. able ) EZIE] p 1 Service recirculation hot water piping in unconditioned spaces shall be insulated to Table 5.12 levels. C3 p 0Heat pump thermostat shall have progamable capability (S. 503.8.3.5) 0 p G2lThermostat provided for each HVAC system with range of 55-75' F.(heating) (S.503.8.1.1). O p Readily accessible, automatic or Manual means provided to restrict or shut-off Heating input to each zone or floor during periods not requiring heat (S. 503.8.3.1). ED s stem (S. 503.2.2(3)). p ontrols for backup heat prohibit simillaneous operation of the primary system p p s echanlcal ventilation system shall have proper timers, and/or switches sv cees V AO, S.302.5) ❑ p z echanical ventllatlon duct i sdulcts n cnnditiol have R-4 ncd spacetion In s s aiil haDve R 4 insulation (VIAO,302.5) 0 p e Mechanical ventilation supply ❑ p a uppiy ducts shall have volume dampers, or the equivalent,to balance system(S. 503.6). p p �o uPPIY and return air ducts shall have sealed duct joints in uncondit oned spaces (S. 503.10.2). ED p VAC plenums, supply,and return air n (Table 5-11, All options) ducts shall have R-8 insulatio p p s leclrlc water heater(s) shall have (S.504.2.1, 504.3, 504.4) :❑ 1987 NAECA Lable on tank Elseparate power shut-off ttings 120 F. ❑noncompressible R10 pad (unheated spaces only) ❑ Temperature se ❑ ❑ E)Showers and lavatories shall limit flow to s 3.0 gallons/minute (S. 504.8.1). ❑ p Swimming poois(S.504.5) shall have: eater) ❑Pool cover ❑Piping Insulated to S. 503.1 Ci readily accessible ON/OFF ;witch (pump, h ❑ p @DAll fireplaces (VIAO, S.402.3) shall have: o 6 square inch combustion air supplyrl:ict w/ accessible damper directly connected to the fire box ❑ Tight fitting glass or metal doors. S. 4o Tight fitting i hagelue damper ❑ p s Solid fuel burning appliance(s) ❑Tigtit tilting glass or metal doors poutside combustion air source directly connected to the fire box urce:allowed only for(1) new stove C3Exceplion: Non-direct, 4" diameter, dampered,combustion air so installations in existing homes where obstruclionsprecludes direct combustion air, or(2) Central heating systems located in unhealed spaces. Three month,etched track radon monitor,printed Instructions, and information sheets shall be supplied ❑ ❑ general contractor(VIAO,S. to the single family dwelling or first floor units of multi-family dwellings by'. 502.2.1), WSEC Final phase requirements: __Date Inspecled by:_-- _. ----- ---- Page 6 of 6