1405 73RD ST SE 2018-01-02 MF Import

COMPLIANCE REQUIRED INSPECTION IMPORTANT: AO NOT place Checks In the two left columns. APPROVED PHASEFINAL tiod) ❑ ❑ @D Exposed foam Insulation shall comply as follows (S. 502.1.4.7): ❑ Protected with metal or plastic flashing, or other suitable material that extends below grade. ❑ Insulation Is approved for sub -grade, exterior use and properly Installed. ❑ ❑ QAIHiow between fresh air ports and the whole -house Ian ensured by undercut dours/grills(VIAQ,S. 302.6.4) ❑ ❑ OLoosefill Insulation OK If (S.502.1.4.5): ❑ maximum ceiling slope not > 3 in 12 ❑> 30" of clear distance from top of bottom chord to underside of root sheathing at the roof ridge. ❑ ❑ ge 6 mil black polyethylene ground cover, shall be lapped 12" at joints and extend to foundation wall ❑ ❑ o Clearances shall meet listed minimums between Insulation and (S.502.1.4.3): ❑ chimney ❑ Non -IC rated recessed lights: 1/2" to oombustables, 3" to Insulation. ❑ ❑ 0 ttic hatch shall be Insulated to required ceiling R-value and Is weatherstripped (S.502.1.4.4) ❑ ❑ FiAtlic access shall have wood dam or equivalent to retain loose fill Insulation in attic(S. 502.1.4.4) II exterior doors (except 20 minute doors) shall be weatherstripped (S. 502.4.3). ❑ ❑ervice hot & cold water piping In unconditioned spaces shall be Insulated to R-3(S. 503.11) ❑ ❑ervice recirculation hot water piping in unconditioned spaces shall be insulated (Table 5-12). ❑ ❑ eat pump thermostat shall have progamable capability (S. 503.8.3.5) ❑ ❑ lReadily hermoslat provided for each HVAC system with range of 55.75' F.(heating) (S.503.8.1.1). ❑ ❑ accessible, automatic or Manual means provided to restrict or shut-off Heating Input to each zone or floor during periods not requiring heat (S. 503.8.3.1). ❑ ❑ ntrols for backup heat prohibit similtaneous operation of the primary system (S. 503.2.2(3)). ❑ ❑ echanical ventilation system shall have proper timers, and/or switches (VIAQ, S. 302.3). ❑ ❑ o echanical ventilation exhaust ducts in unconditioned spaces shall have R-4 Ins. (VIAQ, S. 302.5) ❑ ❑ + echanical ventilation supply ducts In rondit oned spaces shall have R-4 ins.(VIAQ, 302.5) ❑ ❑ 2 upply ducts shall have volume dampers, or the equivalent, to balance system inq IS. 503.6). ❑ ❑ a uppiy and return air ducts shall have sealed duct joints In unconditioned space. (S. 503.10.2). ❑ ❑ + VAC p:inums, supply, and return air ducts shall have R-8 insulation (Table 5.11, All options) ❑ ❑ a Water hester(s) shall have (S. 504.2.1, 504.3, 504.4): ❑ separate power, or gas shut-off ❑ 1987 NAECA Label on tank ❑ Elect only: noncompressible R10 pad (unheated spaces, slabs) ❑ Temperature settings 120 F. ❑ ❑ @DShowers and lavatories shall limit flow to s 3.0 gallons/minute (S. 504.8.1). ❑ ❑ @DSwimmir.g poois(S. 504.5) shall have: ❑ readily accessible ON/OFF switch (pump, heater) ❑Pool cover ❑Piping insulated to S. 503.11 ❑ ❑ Sa All fireplaces (VIAQ. S. 402.3) shall have: ❑ 6 square Inch combustion air suppiyduct w/ accessible damper directly connected to the fire box ❑ Tight fitting glass or metal doors. ❑ Tight fitting flue damper ❑ ❑ e Solld fuel burning appliance(s) (VIAQ, S. 402.2) shall have: [I Tight fitting glass or metal doors ❑Outside combustion air source directly connected to the fire box ❑Exception: Non -direct, 4" diameter, dampered, combustion air source: allowed only for (1) new stove Installations in existing homes where obstructions preclude direct combustion air, or (2) Central heating systems located in unheated spaces. ❑ ❑@D Three month, etched track radon monitor, printed instructions, and Information ; heets shall be supplied to the single family dwelling or first floor units of multi -family dwellings by the general contractor (VIAQ,S. 502.2.1), WSEC Final phase requirements: Dare_ _ Inspected bt:_ _ _ _ Page 8